What are Dimensions of Replacement M8 x 16.5 mm Stainless Steel Rectangular T-Bolt

Question

Question:

What are the dimensions of the stainless rectangle n RR72XB? Will this fit in the RTS507 tracks?

asked by: Kevin W

0

Expert Reply:

The rectangular bolt head of RR72XB is 1 13/16" long x 7/8" tall x 1/8" thick. The type of track nuts that would fit into the # RTS507 would be the part # RRQMFK11 though. The # RR72XB is for fitting into the top channel of the crossbars.

expert reply by: Jameson C

0

Answer 1

The Rhino Rack Vortex Pipe Clamps for Conduit Carriers #RRSPC4 will allow you to carry a 4" conduit on your Yakima HD cross bars. The Vortex uses the same size t-slots as your Yakima HD bars. The Conduit Clamp Set #RRBC2 uses M8 Channel Nuts…

view full answer...

Answer 2

The correct T-Channel nuts you need for the HD crossbars on your Pioneer platform rack can be found here: Replacement M8 Channel Nut for Rhino-Rack Accessories - #RR59TB The Rhino-Rack HD crossbars are definitely a different breed of crossbar which…

view full answer...

Answer 3

Yes. The Replacement M8 x 16.5 mm Stainless Steel Rectangular T-Bolts for Rhino-Rack Accessories - Qty 4 #RR72XB will fit in the t-slot channels on the Pioneer platforms.

view full answer...

Answer 4

I measured the widths of the c-channel on the Rhino Rack Vortex Aero Crossbars and the bottom width is 7/8 inches and the neck width is 7/16 inches. I have attached a photo showing these measurements for you to check out. As long as the t-bolts on…

view full answer...

Answer 5

I have a solution for you as Thule does not offer a separate tension bolt for your Crossroad TH450 Roof Mounted Railing Foot. They only offer the Replacement Handle Assembly #753-20064, the Endcap #853-3593 and the Foot #753-3399. The Foot will…

view full answer...

Answer 6

There is actually a carrier specifically for your application. Well, not vaulting poles, but 6 inch PVC pipe. Take a look at Conduit Carrier Kit # RP7054900. It fits 6 inch diameter PVC schedule 40 or 80 and this set up can be locked using a padlock…

view full answer...

Answer 7

The threaded portion is 1" long on the Replacement M8 x 16 mm Rectangular Head T-Bolt for Rhino-Rack Accessories - Qty 1 item #RR89HB.

view full answer...

Answer 8

Here are the 2 different mounting options for installing the Batwing and Foxwing Awning Relocation Kit #RR31102. You can change the orientation of the brackets so that the awning will either hang higher or lower depending on your application.

view full answer...

Answer 9

While we do have some T-Bolts #RR72XB which will fit into the TS Rails for TruXedo Elevate Rack System #TH65FR. I recommend using the hardware which comes with the Tie-Down Kit #TH52FR since the kit comes with 8 T-Bolts as well as washers and nuts.…

view full answer...

What are Dimensions of Replacement M8 x 16.5 mm Stainless Steel Rectangular T-Bolt

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching