Recommended Tuson DirecLink Trailer Brake Controller For 2013 Freightliner M2 112 Towing Car Hauler

Question

Question:

Im searching for a brake controller for my 2013 freghtliner m2 112 pulling a kaufman wedge car hauler. My question is would i benefit from a 335DL-200NE or a 335DL-100 would be fine ? What do you guys recommend thanks

asked by: Hector C

0

Expert Reply:

The Tuson DirecLink Base Model Trailer Brake Controller - 1 to 4 Axles - Proportional # 335DL-100 you were looking at for your 2013 Freightliner M2 112 pulling a Kaufman Wedge Car Hauler will be perfect. The 335DL-200NE you were looking at has actually been discontinued by the manufacturer.

To install the # 335DL-100 in your truck you will need the Tuson Heavy Duty Truck Module Kit for DirecLink Brake Controller - 9 Pin # 335HDCON-9PIN If your truck has a 9-pin Deutsch connector, or the # 335HDCON-6PIN f your truck has a 6-pin Deutsch connector.

I included a few video reviews of the products mentioned for you to take a look at.

expert reply by: Samuel C

0

Answer 1

I reached out to Peterson and found that the LumenX LED Trailer Backup Light - 7 Diodes - Clear Lens #PE37ZV is 230 lumens.

view full answer...

Answer 2

I do have an option for you but there aren't any custom fit trailer hitch options for a 2006 Thomas School Bus. That said, we do still have universal options which can be installed either via welding or cutting/drilling. For this, I recommend the…

view full answer...

Answer 3

While we have a potential option for you, the hitches that fit a 2000 Chevy Express van have mounting holes 40 inches apart, and additionally the manufacturers expressly state they do not fit the cutaway models, so you will need one of the universal…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 7

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 8

I don't believe a 2016 Volvo VNL780 has electric brake wiring since they are setup for the air brakes of a semi truck trailer but the Tuson DirecLink Base Model Trailer Brake Controller #335DL-100 can still be used as long as it has a 12 volt…

view full answer...

Answer 9

The Entegra Coach Vision is built on a Ford F-53 Chassis which means there should be a pre-wired brake controller port under the dash. The exact location of this port can vary but most likely it will be on the left side of the steering column support…

view full answer...

Answer 10

You certainly can! Installing a brake controller is fairly easy if you are familiar with running wiring. To install a brake controller like the popular Tekonsha Prodigy P3 #90195 you will need to run the wires on the pigtail to the following…

view full answer...

Answer 11

There are a number of factors involved when converting a semi 7-way to an RV 7-way. Semis generally use a 7-pin round pin socket, similar to #PK11720. And RV style 7-way uses blades, like #PK12706. We do not offer any pre-made adapters to make this…

view full answer...

Answer 12

Since even semi trucks like what you have use OBDII connectors the Tuson DirecLink Base Model Trailer Brake Controller #335DL-100 that you referenced can be used. The module of this is what interprets the brake signal from your tow vehicle and…

view full answer...

Recommended Tuson DirecLink Trailer Brake Controller For 2013 Freightliner M2 112 Towing Car Hauler

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching