Can I Replace the Converter Only in My Power Control Center and Power Panel

Question

Question:

So if I have a power system/breaker/fuse box with a built in converter does that mean everytime the converter goes bad i have to replace the whole assembly or can i just switch out the converter?

asked by: Bonfire56

1

Helpful Expert Reply:

The Replacement Converter Section for Progressive Dynamics 4500 Series RV Power Control Center - 90 Amp # PD4590CSV is the converter section you're referring to, so in most cases the converter can be swapped out for a new one. This converter would be found in something like the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 90 Amp # PD4590K18LS8.

expert reply by: Erik B

1

Answer 1

Yes, the Progressive Dynamics #PD4590CSV replacement converter section is the correct replacement part for the Progressive Dynamics #PD4590K18LS8 power center. Be sure to change set the Lithium VS Lead Acid switch on the converter depending on your…

view full answer...

Answer 2

Yes. You can replace the Progressive Dynamics PD4590K18NS2 with the Replacement Converter Section for Progressive Dynamics 4500 Series RV Power Control Center - 90 Amp #PD4590CSV without any issues. Both are 90 amp converters from the same Series and…

view full answer...

Answer 3

I spoke to Progressive Dynamics, the Progressive Dynamics REL 90A 4500 Series Inteli-Power Converter Section part #PD4590CSV is a fit for you 4590 panel. You have an older style panel which uses a different fan layout but the above will fit and is…

view full answer...

Answer 4

I recommend looking at the Go Power RV Converter and Smart Battery Charger #34266912 which has a maximum output of 14.4v and is designed to work with AGM batteries. This is the most powerful converter and smart battery charger we have and it is rated…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 9

The Progressive Dynamics Converter #PD4655V is specifically designed to replace the WFCO 8955 you have on your 2014 Thor Hurricane 27K motorhome. This is compatible with your two 6volt batteries as they are going to be wired in series to create 12V…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Can I Replace the Converter Only in My Power Control Center and Power Panel

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching