Replacement Truxedo Lo Pro Tarp for 2012 Ford F-150

Question

Question:

Which replacement cover to order for my ripped lo pro truxedo cover. 2012 Ford F-150 fx.

asked by: Eric W

0

Expert Reply:

If your 2012 Ford F-150 has a 5-1/2 foot bed you'd need the tarp part # TX577601-CVR, if you have a 6-1/2 foot bed you'd need # TX1117655, or if you have an 8 foot bed part # TX5986-CVR.

expert reply by: Jameson C

0

Answer 1

The best method to identify the tonneau cover on your 2008 GMC Sierra will be to look for the date code and or serial number. The serial number is located on the driver's side of the front header on the TruXport frame. The date code is printed on…

view full answer...

Answer 2

We do have a couple of replacement TruXedo covers available for tonneau covers that are confirmed to fit your 2011 Ford F-150 with a 5-1/2 foot bed, without the bed cargo management system. The correct replacement cover will depend on the model…

view full answer...

Answer 3

If you have the Lo Pro Soft Roll-Up Tonneau Cover, part #TX597601, that fits a 2011 Ford F-150, the replacement tarp you need is the Replacement Tarp for TruXedo Lo Pro Soft Tonneau Cover, part #TX577601-CVR. I have included a product description…

view full answer...

Answer 4

The original Lo-Pro Tonneau covers have been discontinued for a while now but were replaced by the Lo-Pro QT. The replacement cover for the Lo-Pro QT for your 2002 Chevy Silverado 1500 with 6-1/2 foot bed is #TX1117651. The cover attaches to the side…

view full answer...

Answer 5

Hey Chris, Because the Thule TracRac TracONE Truck Bed Ladder Rack #TH27000XTB clamps to the lip of the bedrails it won't be compatible with any tonneau cover. You would need Thule's stake pocket mounted version the TracRac SR #TH43002XT-508…

view full answer...

Answer 6

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

view full answer...

Answer 7

Hey Roy, The only U-bolt kit we currently only offer for 1-1/2" square axles is part #CE23102, which only has a 3-3/8" length so it likely wouldn't be the best option for you. Instead you'll want to order the 1-1/2" Square…

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

I believe you're talking about the Furrion Propane RV Built-in Wall Oven #FSRD22LASS. This is 20-11/16" tall but the width is more than you can fit at 24-3/4" wide. These are the same dimensions as the Furrion Electric RV Built-in Wall…

view full answer...

Answer 11

Your 2013 Ford F-150 must have come with the factory 4-Way connector. Since the harness for that connector uses a square plug and not the round plug, a simple plug and play 7-Way is not available. You will have to partially hardwire in a 7-Way using…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replacement Truxedo Lo Pro Tarp for 2012 Ford F-150

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching