Vent Cover Replacement Recommendation

Question

Question:

I have a 2019 Dutchman Kodiak Ultra Lite Travel Trailer...my roof vents were damaged in a hail storm...the opening is 13 1/2inch x 13 1/2inch for both vents... the current vent measures 15x15inch on the outside of it...can I purchase a 14inch x 14inch vent cover? Also, I would like to purchase a cover for each one of those....what will fit with them?

asked by: Dan M

0

Expert Reply:

The MaxxAir UniMaxx Universal Replacement Lid for RV and Trailer Roof Vent - Translucent White Item # MA00-335001 is a universal fit and works with Elixir, Ventline, Jensen, Hengs, and other roof vents.

expert reply by: Kevin C

0

Answer 1

Yes, the correct replacement lid cover for your MaxxFan Plus Roof Vent w/ 12V Fan part #MA00-04500K (4951KS) is the Replacement Lid for MaxxFan and MaxxFan Plus Roof Vents part #MA10A40009K.

view full answer...

Answer 2

The Carrier Air V RV Air Conditioner is no longer produced so a direct replacement of the same unit is not an option. However, we do have available the two Advent AC models that are designed as replacement units for the Carrier Air V. I recommend…

view full answer...

Answer 3

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

view full answer...

Answer 4

Entry door locks, like the Bauer Products #BA64FR, typically will have a sticker on the inner handle portion that sits inside your RV, but I have installed a few where they also have the key code on a sticker on the inner components of the handle.…

view full answer...

Answer 5

As it turns out, almost all trailer roof vents are 14" X 14", +/- 1/4". Your best choice is the MaxxAir #MA00-335001 Universal Replacement Lid. The continuous hinge versions are better than the 3-tab versions. The hinge on this unit is…

view full answer...

Answer 6

Hey Thomas, If your roof vent is 14" x 14" then you could go with the MaxxAir UniMaxx Universal Replacement Lid for RV and Trailer Roof Vent #MA00-335001. This replacement is a universal-fit for Elixir, Ventline, Jensen, Hengs, and other…

view full answer...

Answer 7

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 8

With the pandemic and Dometic taking over Atwood's water heater division it has been very hard to come by replacements. My honest recommendation is to go tankless and replace your Atwood GCH10A-4E with the Furrion RV Tankless Water Heater 60,000…

view full answer...

Answer 9

The correct replacement lid/dome for a MaxxFan* 4751KS is the Replacement Lid for MaxxFan and MaxxFan Plus Roof Vents part #MA10A40009K for black or part #MA10A40002K for white.

view full answer...

Vent Cover Replacement Recommendation

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching