Will TorkLift StableLoads and SuperSprings Work Together On a 2013 Ford F-250

Question

Question:

Will these work in addition with SuperSprings Custom Suspension Stabilizer and Sway Control Kit? Or are they not needed because the SuperSprings are enough?

asked by: Terry B

0

Expert Reply:

Yes, the TorkLift StableLoad Rear Suspension Upgrade can be used along with the SuperSprings Custom Suspension Stabilizer and Sway Control Kit. The correct kit for a 2013 Ford F-250 is part # TLA7310 for the StableLoad and part # SSA16 for the SuperSprings. They will both do a great job of providing additional support on their own but you can stack them if you feel more support is needed for your setup.

expert reply by: Conner L

0

Answer 1

Thanks for that info, and for your 2022 Ford F-350 Super Duty, the better option between the Timbren and SumoSprings for towing a 5th wheel trailer are the Timbrens, with the correct fit for your truck being the following: - Timbren Suspension…

view full answer...

Answer 2

I recommend the SuperSprings Custom Suspension Stabilizer and Sway Control Kit part #SSA13MXKT for a 2016 Chevrolet Silverado 2500 which is rated at 3,000 lbs over part #SSA16MXKT which is rated for 1,650 lbs. The reason being, the heavier…

view full answer...

Answer 3

The Air Lift Ride Control Air Helper Springs, #AL59533 are confirmed to fit the 2019 GMC Canyon but cannot be used on a lifted vehicle. I suggest the RoadActive Suspension Custom Leaf Spring Enhancement Kit, #RAS4617 as long as you still have the…

view full answer...

Answer 4

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 5

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 9

According to my contact at Fantastic Vent the correct replacement lift motor to use in your vent is part #FVK6010-81, not item FVK-6050-80. The replacement motor does operate at a higher 17-RPM speed. Since your fan is of a lower rpm and manufactured…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Will TorkLift StableLoads and SuperSprings Work Together On a 2013 Ford F-250

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching