Hole Spacing on Hand Rail for 2nd Generation MORryde StepAbove Steps

Question

Question:

need to know the spacing of the mounting bolts, I have a 2021 model Montana with 4 step entry steps.

asked by: John A

0

Expert Reply:

The Handrail for Second Generation MORryde StepAbove and StepAbove with Strut Assist Steps # MR73AR bolt holes are 3/4" apart center on center on the curved side and 4-1/2" apart on the long side.

expert reply by: Erik B

0

Answer 1

The MORryde StepAbove RV Steps #MR28RR are a second generation step. This will require the Handrail for Second Generation 4-Step MORryde Steps #MR73AR. To determine which generation step you have you can measure the threaded holes for the steps. On…

view full answer...

Answer 2

I do have an option for you but the Stromberg Carlson 4000 Series 5th Wheel Louvered Tailgate part #VGD-10-4000 does not have a spot for the factory backup camera. Therefore you would either need to find a way to mount this yourself, go without, or…

view full answer...

Answer 3

Most manufacturers are in the process of discontinuing their fifth wheel tailgates with the camera relocation kits due to mechanical issues. Therefore I could not find one that fits your 2017 Ford F-350 Super Duty. The Stromberg Carlson 4000 Series…

view full answer...

Answer 4

The easiest way to determine if you have a first or second generation MORryde Stepabove 3-step setup is to look at the way the step legs lock and adjust. If they have a removable pin you have a first generation and need the part #MR93RR. If instead…

view full answer...

Answer 5

I spoke with a MORryde tech and found that the 36" measurement would be pretty close to the end of the leg adjustment slots but that you would still have 2-4" of adjustability. The issue that you'll run into though is that the first…

view full answer...

Answer 6

The difference is between just the MORryde Locking RV Storage Box #MR43RR and when you add the brackets at their widest setting. Just the box measures 25-3/4" but when you add the mounting brackets is when you'll see that 27-3/4" width…

view full answer...

Answer 7

Hey Scott, so since you have a Dometic AC unit currently the replacement you'd want is the Advent Air part #ACDOM150 which was designed to replace Dometic units which means a really simple install that allows you to use current wiring and…

view full answer...

Answer 8

You will want to look at the legs of your steps to determine which MORryde steps you have. If your MORryde steps have a pull pin then you've got the 1st generation. If you have a button that releases the legs for adjustment, you have the second…

view full answer...

Answer 9

Though I do have a solution for you, however there isn't a kit that will allow you to convert your MORryde steps to strut assisted steps. The only option that we would have for you is to replace your steps with steps that already have the strut…

view full answer...

Answer 10

Sounds like you might be looking for the Handrail for Second Generation MORryde StepAbove and StepAbove with Strut Assist Steps - Triple #MR83AR; the difference between the 1st generation and 2nd generation steps are that the 2nd Gen leg adjustment…

view full answer...

Hole Spacing on Hand Rail for 2nd Generation MORryde StepAbove Steps

Product Page this Question was Asked From

Continue Researching