Does Progressive Dynamics Inteli-Power RV Converter Have Circuit Protection

Question

Question:

does this converter have Protection features? Surge protection? Does it buzz?

asked by: Deb O

0

Expert Reply:

Yes the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger # PD9245C does have safety features built into it that will protect from surges as well as other issues. It does not buzz or make any sounds.

expert reply by: Jameson C

0

Answer 1

Yes, you can use the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger #PD9245C on a set of two batteries wired in parallel with an output of 12 volts.

view full answer...

Answer 2

When you move up to a larger amperage converter you just need to ensure that your wiring is the correct gauge to support the higher amperage. Since you're only going from 40 to 45 amps you're more than likely fine. The next important step is…

view full answer...

Answer 3

The generator provides AC amperage to your trailer which is about 10 times more powerful than DC amperage. The 30 amps that you get from it would essentially be 300 amps in DC power available for use. Converters like the #PD9245C charge your battery…

view full answer...

Answer 4

The great thing about DC power sources is that you can run multiple power sources together without issue unlike AC power which requires transfer switches. So the converter part #PD9245C ran to your panel along with your solar panel controller would…

view full answer...

Answer 5

It looks like you've got a 45 amp converter that you're looking to replace, so if you've got a lead acid battery I recommend using the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger - 12V - 45 Amps #PD9245C. This…

view full answer...

Answer 6

The first thing I would want to know here is where you tested the voltage at on the Charge Wizard #PD92201 - if you didn't test it directly at the converter box, you'll want to start there. If the voltage at the converter is different than…

view full answer...

Answer 7

In storage mode, the output voltage increases to 14.4v DC for approximately 15 minutes every 21 hours to help prevent sulfation of the battery plates. The converter output should be 13.6. When disconnected from the battery, or when the batteries are…

view full answer...

Answer 8

I reached out to my contact at Progressive Dynamics regarding the Progressive Dynamics #PD92201 Charge Wizard, and was told, "Yes," you can cut the cable and splice in additional length. They advised to use shielded cable and not to exceed…

view full answer...

Answer 9

I do have a simple wiring diagram for the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger - 12V - 45 Amps #PD9245C. Basically you just need to run the power wire from the converter directly to the DC distribution panel and…

view full answer...

Answer 10

The Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger - 12V - 45 Amps #PD9245C is compatible with AGM batteries. The converter is compatible with flooded lead acid, AGM, and gel batteries, and will charge the battery to 100…

view full answer...

Answer 11

I recommend you start by just replacing the fuses. If that fixes the problem, you are all set. If not, I recommend replacing the power converter with a new unit. I can recommend a similar model to replace your existing converter if you can find the…

view full answer...

Answer 12

The Progressive Dynamics PD9200 Series Inteli-Power Converter - 12 Volts - 45 Amps #PD9245C is 8-1/4" long x 7-1/4" wide x 4-11/16" deep. If this fits in the slot you are referring to in the bottom of the power panel then you will be…

view full answer...