Floor Seal for Dometic 311 RV Toilet # DOM77FR

Question

Question:

Does this come with the seal that installs between the toilet and floor flange? Thanks

asked by: Jeff

0

Expert Reply:

Yes, the Dometic # DOM77FR does come with a floor seal. It will likely be already stuck to the bottom of the toilet in the correct location as shown in the product pictures. It will also come with new hardware to bolt the toilet to the floor.

expert reply by: Les D

0

Answer 1

Dometic has recalled the 301's and ensured that the other models don't follow in the same design. The replacement you're looking for is with the 310 or 311 models, of which we have two options; the #DOM24FR is made of polypropylene and…

view full answer...

Answer 2

For a great low-profile toilet, I recommend the Dometic 311 Part-Timer RV Toilet - Low Profile #DOM67FR. Not only does this toilet only measure 15-1/2 inches high, I confirmed with Dometic that the trap stays open while the pedal is compressed. The…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Floor Seal for Dometic 311 RV Toilet # DOM77FR

Product Page this Question was Asked From

Continue Researching