Troubleshooting Trailer Wiring Running Light Fuse Blowing
Question:
I have break lights and turn signals but the running lights are not working. I have tried two fuses in f29 and both have blown. What could be causing this?
asked by: Ron T
0
Expert Reply:
There's a short on the running light circuit that is causing the circuit to blow the fuse. You need to go over the wiring of the circuit looking for any cut or exposed wire and fix as needed. I also attached a help article on troubleshooting trailer wiring for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Comparing The Air Lift WirelessONE Compressor System # AL25980EZ And # AL25980
- Q&A: Replacement Module for Air Lift Compressor
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: Wiring Diagram for the Curt Universal Brake Controller Harness
- Q&A: Tandem Axle Trailer Hanger Kit that Uses Flat Center Equalizers
- Q&A: Determining Correct Replacement Leaf Spring For Trailer W/ 3000lb Axles and 27" Long Springs
- Article: Best Air Bag Suspension (2023)
- Q&A: Can Weight Distribution and Air Bag Suspension Enhancement Work Together and Which to Setup First
- Q&A: Air Bag Recommendation for a 2023 GMC Sierra 1500 Denali with Adaptive Ride Control
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)