Retracted and Extended Height of Dutton Lainson Trailer Jack DL22530

Question

Question:

What is the retracted length of this jack?

asked by: Sandra L

0

Expert Reply:

The retracted height of the Dutton Lainson Trailer Jack # DL22530 is 8-1/4 inches and the extended height is 23-1/4 inch. From the mounting bracket to the top of the jack measures 15-1/4 inches.

expert reply by: Jameson C

0

Answer 1

In regards to the A-Frame Trailer Jack part #DL22530, the handle sits at a 90 degree angle in relation to the rear two mounting holes. The distance between the inside of the handle and the outer tube of the jack is 1-1/8". I have filled these…

view full answer...

Answer 2

I went out to our warehouse and measured the Dutton-Lainson Trailer Jack, #DL22530, the mounting flange hole size is 7/16 inches x 3/4 inches and the dimensions from center of one hole to the center of the next hole is 3 inches. They are equally…

view full answer...

Answer 3

Yes. The distance from the bracket to the bottom of the jack when retracted is 9 inches. The bolt holes on the mounting flange are 3 inches from center of one hole to the center of the next hole. The holes are equally spaced around the flange.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

To replace your converter you have two options: Option 1: Completely replace the converter and AC/DC distribution panel. You could use a power center like the #PD4135K or a larger one if you'd like a higher amperage converter and more AC circuit…

view full answer...

Answer 7

I have good news, our trailer jack that has a 2 inch outer diameter part #DL74MR would fit and work well. While it has a 1,000 lb weight capacity that does not mean 1,000 lb total trailer weight capacity. That capacity is the tongue weight capacity…

view full answer...

Retracted and Extended Height of Dutton Lainson Trailer Jack DL22530

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching