How Far Does the Handle Pull Out on the Dometic Portable Camping Toilet

Question

Question:

To see if the DOM34FR portable toilet will be useable in my small camper shower stall, I need some measurements! With the shutter blade handle fully extended outward, what is the toilet length or how far beyond the front of the toilet does the handle extrude when fully pulled out? Also, what is the measurement of clearance from the floor to the bottom of the blade handle when it is extended outward? It needs to clear the edge of the shower stall bottom enclosure.

asked by: Tom

1

Helpful Expert Reply:

The handle of the Dometic Portable Camping Toilet # DOM34FR pulls out 3-9/16" from the base and the lowest part of the handle is 2-1/4" from the ground. I've added a photo to try to illustrate these dimensions better.

expert reply by: Erik B

1

dimensions of handle pull out
(click to enlarge)

Answer 1

I reached out to Dometic and both the #DOM34FR and #DOM44FR can hold up to 350 lbs.

view full answer...

Answer 2

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 3

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 4

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the industry…

view full answer...

Answer 5

To determine the correct Sidewinder for your 2025 Keystone Cougar 2700BH we'll need to first determine the bolt pattern. There's typically a sticker some where on the pin box or mounting ears that has a serial number, LCI item number, and RPO…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Yes, the Timbken bearings part #TMK73VR and #TMK23VR are made in the USA.

view full answer...

Answer 8

The CargoSmart Anti-Rattle D-Ring Tie-Down Anchor #3486553 will require 1/4" mounting hardware. The center hole measurements for the bolt holes are 1-3/8" apart. At this time we will not have any square u-bolts that will fit the anchor.

view full answer...

Answer 9

My TruXedo representative confirms that the #TX22AR Stake Pocket Covers are indeed compatible with the factory installed black plastic covers on the tops of the bed sides.

view full answer...

Answer 10

Yes! To replace the override plug on your Lippert Electric Trailer Jack with Footplate #LC285318 you need the Kit #LC733924 which comes with 2 of them.

view full answer...

Answer 11

Email me back with the picture and I'll see if we can match it.

view full answer...

Answer 12

In order to install a Fulton Fold-Away Coupler Hinge Kit like part #FHDPB230101 on a trailer with surge brakes you are going to want to use a flexible brake line that runs from the actuator to the t-fitting just before it splits to each braking…

view full answer...

How Far Does the Handle Pull Out on the Dometic Portable Camping Toilet

Product Page this Question was Asked From

Continue Researching