Replacement Strap for Fulton T2625 Hand Winch

Question

Question:

I have a t2625 fulton winch and it says 2600 lbs on the side, it has a 17/8 strap which strap do I need to replace it with.

asked by: Barry

1

Helpful Expert Reply:

The replacement strap for your Fulton T2625 winch is part # FWS20HD0200 which is a 20 x 2 inch strap with a capacity of 4000 lbs.

expert reply by: Mike L

1

Answer 1

The Fulton High-Performance 2-Speed Trailer Winch #F142412 that you referenced does not come with a strap. It is compatible with a 2 inch wide strap and the drum can accept a strap length of up to 20 feet. With this in mind the Fulton #FWS20HD0200…

view full answer...

Answer 2

Yes, you can use a strap with your Fulton High-Performance 2-Speed Trailer Winch part #F142412 (T2625). For this, I recommend using the Fulton Heavy-Duty Winch Strap with Hook part #FWS20HD0200. This strap is a direct fit for your winch and has a…

view full answer...

Answer 3

Your trailer must have free backing brakes if you have never used the surge brake actuating coupler reverse lockout. If you did not have free backing brakes, your brakes would most likely brake even if they didn't lock up when you back up because…

view full answer...

Answer 4

First you are going to need to determine if your particular winch can be used with a strap instead of a cable. Some winches will accept either but other winches must be used with one or the other. Contact your winch manufacturer to determine if your…

view full answer...

Answer 5

The biggest difference between the servo styles that you'll notice is between free backing plates and the others. The free-backing plates will allow your trailer to back up without having the brakes lock up. With surge brakes typically when you…

view full answer...

Answer 6

For 10 inch brakes like #AKUBRK-35-D you can use nut and lock washer set (8 each) #BRKH10B. If you want to source stainless or galvanized nuts locally then they should be 7/16"-20.

view full answer...

Answer 7

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 8

You are correct, pushing the trailer with the #DM72VR uphill will cause the brakes to activate so this will be a problem. Typically you could add an electric lockout using the #DM5836, but since you are pushing it forward you would need some custom…

view full answer...

Answer 9

I went ahead and called my contact at Redline Trailer Repair Parts, and they confirmed that nuts in the Mounting Hardware for 10" Brake Assemblies #BRKH10B have a diameter of 7/16mm and have 20 threads per inch. Unfortunately, there are no bolts…

view full answer...

Answer 10

If you replace the current brakes on your trailer with the same uni-servo drum brakes and no lockout actuator (like #T2351000), the brakes will deliver 20 percent braking when traveling in reverse. However, the more pressure you apply going backwards…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Replacement Strap for Fulton T2625 Hand Winch

Product Page this Question was Asked From

Continue Researching