Install Harness for Redarc Tow Pro Liberty for 2013 Mercedes Sprinter 3500

Question

Question:

Will the Redarc Liberty RED24FR controller work with the 3063-P adaptor cable for my 2013 Sprinter 3500?

asked by: Charlie

0

Expert Reply:

Yes the Redarc Tow Pro Liberty part # RED24FR can be installed in your 2013 Mercedes Sprinter with the install harness part # 3063-P.

expert reply by: Jameson C

0

Answer 1

The Dexter Trailer Hub Assembly you referenced, part #AKIHUB-440-2-1K is known as an idler hub. An idler is a hub that is no provisions for trailer brakes. It has no brake drum. Part #8-276-5 is an example of a hub/ drum that has a brake drum that…

view full answer...

Answer 2

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 3

To install a Redarc Tow Pro Elite part #RED63RR on your 2021 Sprinter requires the install harness part #3030-P which at this moment is on back order. For a 2008 Sprinter the correct harness instead is the part #3063-P.

view full answer...

Answer 4

The Tekonsha Prodigy P3 Trailer Brake Controller #90195 along with the wiring harness #3063-P is all that is needed to add your controller to your Sprinter with Factory Trailer Plug. Since you are not getting power, you should check fuse F55 which is…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 9

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Install Harness for Redarc Tow Pro Liberty for 2013 Mercedes Sprinter 3500

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching