Will Bearing Buddy Fit on EZ Lube Spindle
Question:
My boat trailer has the grease zirk at the end of the axle, the bearing buddy will fit as is, my question do I have to remove the grease zirk before I install the bearing buddy or do I just leave it in and install the bearing buddy and fill it with grease?
asked by: Usbaldo V
0
Expert Reply:
Bearing Buddies can fit on EZ lube spindles but you'll need to rip off the zerk fitting at the end of the spindle. A large set of pliers will work for this.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1980A w/ Auto Check - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.98 Inch
- Bearing Buddy
more information >
Continue Researching
- Q&A: Will the Bearing Buddy Bearing Protectors Work With EZ-Lube Axles
- Q&A: Do Bearing Buddies Work Well on Travel Trailer Hubs
- Q&A: Should Bearing Buddies Buddies be Used on EZ Lube Trailer Axles
- Q&A: Brake Magnets on Trailer are Only Showing 9 Volts
- Q&A: Should I Have Constant 12 Volt Power On Brake Output Pin On 7-Way Connector
- Q&A: How To Tell If Bearing Buddy Has Enough Grease
- Q&A: When Using Bearing Buddy Bearing Protectors Do I Need To Repack Bearings Periodically?