Picking Out Replacement Regulator for Dryer and Gas Stove

Question

Question:

Have a 100lb bottle hooking to a full size gas stove and full size dryer what size regulator do I ne

asked by: Tim F

0

Expert Reply:

You'll have to check the appliances for their propane pressure requirements. Most likely you need LP low pressure like what the part # 108220 provides. Or if you need high pressure you'd need the part # 108072.

expert reply by: Jameson C

0

Answer 1

Thanks for the picture of the LP requirements of your dryer. It uses a standard 10 water column propane pressure rating so the regulator part #108220 that you referenced is a good start since that is what this is designed for as well. You'll need…

view full answer...

Answer 2

For a single tank setup the regulator you would want is the part #108220 which is rated for 400,000 btus. The regulator you mentioned does not have enough BTU.

view full answer...

Answer 3

The JR Products Horizontal 2-Stage Propane Regulator part #37207-30375 is what I recommend as a direct replacement for the Marshall 605H Propane Regulator. Please note, you'll need to use thread tape like the part #A05-0265 on the outlet side of…

view full answer...

Answer 4

I went ahead and checked to see what we have an unfortunately it does not appear that we have a hose that will connect your regulator with a 3/4" FPOL inlet to your 100-lb propane tank, however I do have another solution. I know it is not ideal,…

view full answer...

Answer 5

To add a 100 lb tank to your two tanks, I recommend the MB Sturgis Sturgi-Stay T-Fitting w Hose - Type 1 Valve - Quick Disconnect, Disposable Cylinder Ports #103615. This will allow you to connect the red fitting to one of your tanks and the pigtail…

view full answer...

Answer 6

The propane regulator I recommend for your 100 lb propane tank is the MB Sturgis Vertical 2-Stage Propane Regulator part #108220 which will need to be mounted in a vertical position. In order to then attach this regulator to your 100 lb propane tank…

view full answer...

Answer 7

The water column (WC) rating of the Single Stage Propane Regulator part #108072 would be far too high for your generator. Instead, you are going to want to use a two-stage regulator like the MB Sturgis Vertical 2-Stage Propane Regulator part #108220…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 10

I looked up the hose and the regulator you currently have, and found that the GHA7 hose uses an ACME Nut connector to the LP tank and a 1/4 inch male inverted flare that connects to the 3/8 to 1/4 adapter used on the regulator. We offer the necessary…

view full answer...

Answer 11

The fan in the #PD4645V is temperature controlled so typically it does not run continuously. However, if there are heavy loads you can expect the fan to run non-stop. According to Progressive Dynamics, this can also happen if you're charging…

view full answer...