Rear Bumper Availability For 1993 Ford F-150 Flare Side

Question

Question:

I need a bumper for my F150 Flare Side. Will this fit?

asked by: Milton B

0

Expert Reply:

The Westin Fey Surestep Rear Bumper - Chrome Plated Steel # 76001 is not a confirmed fit for your 1993 F-150. If you had the standard style bed then I would recommend going with Westin Fey Surestep Rear Bumper Chrome Plated Steel # 21002-92230 which is a confirmed fit for 1993 Ford F-150. However, since you mentioned that your F-150 is a FLARE SIDE then this will not work; there are not any bumpers available that are compatible with flare side models.

expert reply by: Andrew N

0

Answer 1

The Westin Fey SureStep Bumper #21002-92230 is a fit for your 1992 F-150 with standard bed and the same is true for the Surestep Deluxe XLT Rear Bumper #21007-92230. The only difference between these two bumpers is that the step-pad surface on…

view full answer...

Answer 2

Looks like you have an older version of the 21007-92230 that you referenced which fits the following: 1973 - 1991 Chevrolet C/K Series Pickup 1973 - 1991 GMC C/K Series Pickup 1967 - 1983 Ford F-100, F-150, F-250, F-350 Standard Bed models 1992 -…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Rear Bumper Availability For 1993 Ford F-150 Flare Side

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching