Ultra Fab Stabilizer Jacks for Minnie Winnie Motorhome

Question:

Will the electric jacks Item # UF39-941704 work on a my 2020 Winnebago Minnie Winnie Motorhome. the frame has a hole 39.5 inches across but the jacks have holes at 68.6875 it will need extended supports. Any help for me I want Electric

asked by: Kenneth R

Expert Reply:

The Ultra Fab # UF39-941704 is the manual version of this stabilizer. For the electric version use the Ultra Fab # UF39-941705 rated for 6000 pounds. The angle brackets screw into the RV frame. You may have to drill some holes.

It might be possible to install a set on your Minnie Winnie 31K but there isn't a lot of space on the underside of that RV so it is possible, even likely, that the stabilizers will not fit. When fully retracted the stabilizers will hang down 5 inches from where they are mounted. The minimum frame width these will fit is 48 inches. Your RV chassis frame width on it is likely less than 48 inches. You should first measure the fram width and see if you have an open area to mount this kit in the back.

A set of scissor jacks such as # UF48-979031 is the better way to go. They take up less space, cost less, and you can use a power drill with adapter # UF48-979005 to raise and lower them faster.

expert reply by: Les D