Recommended Trailer Jack For 2 x 2 Inch Trailer Frame and 200 lb Tongue Weight
Question:
I am looking for a trailer jack that will fit on a 2 X 2 tongue. The load on the jack will be less than 200 pounds. Which of your jacks will fit these requirements? Thank you
asked by: Robert J
Expert Reply:
Assuming you're looking for a swivel jack that mounts to the side of the trailer frame, the etrailer brand
# MJ-1206B would be a good, yet reasonably priced choice and will bolt on to trailer tongues that are between 2 and 4 inches in height, so it'd work well for you. The jack has a 1000 lb capacity and provides a 10-inch lift.
The # FTJ120W0301 Fulton jack you'd looked at would work as well, but it is a weld-on application and is quite a bit more expensive than the one I recommended.
I've linked to a product demonstration video featuring the jack I recommended.
Products Referenced in This Question
etrailer Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1,000 lbs
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 0 - 1000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- etrailer
more information >
Product Page this Question was Asked From
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Are Safety Chains Needed with Lock N Roll Articulating Hitch
- Shop: Roof Rack
- Shop: RV Roof Membrane
- Shop: Ark Drop Down Corner RV Stabilizer Jacks - 24" Long Corner Steadies - Silver - Qty 2
- Shop: Ultra-Fab Power Twin II Electric Stabilizer with Dual Motors - 30" Lift - 6,000 lbs
- Video: Lock N Roll 3-Position Channel Articulating Hitch Review
- Search Results: rhino rack rtc
- Search Results: access door
- Search Results: rv access door
- Search Results: hitch receiver tube
- Search Results: jack
- Search Results: hitch receiver
- Search Results: weld on jack
- Shop: Thinline LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 15 Diodes - Red Lens
- Shop: Electric Ground Control TT Automatic 5-Point Travel Trailer Leveling System - 10,000 lbs
- Shop: Square Direct Weld Jack w/ Footplate - Drop Leg - Sidewind - 28-7/8" Lift - 7,000 lbs
- Shop: Dutton-Lainson Boat Trailer Jack w/ Footplate - Sidewind - Fixed Mount - 30" Lift - Zinc - 2K
- Shop: Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Sidewind - 15-1/2" Travel - 3K
- Shop: Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Video: Choosing the Right Trailer Wiring
- Article: Trailer Tire Sizing
- Shop: Trailer Wiring
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Shop: Suspension Enhancement
- Q&A: What Roof Rack Kits Will Work with the RetraxPRO XR Hard Tonneau Covers
- Shop: Brake Controller
on Trailer Jack
