Initial Adjustment of Self-Adjusting Trailer Brake Assemblies
Question:
I bought 4 etrailer brand brake assemblies for the 2.5 K axle a couple of years ago. I didnt install them until recently. I have trouble with one wheel on the electric brakes locking up but the others do not. Your video says the most likely reason is adjustment. I have the self adjusting version and can adjust the brakes to full lock, but how do I back it off 10 clicks? the self adjusting mechanism would prevent the teeth from rotating back. How do I fix this?
asked by: Dan R
Expert Reply:
To back the adjuster off, you'll need to use a small flat blade screwdriver or a similar tool to lift the clip that sits in the teeth of the adjuster wheel. With the clip lifted out of the way, you can use another screwdriver (a # W80630 adjuster spoon is easier to use).
You can also automatically adjust the brakes if you have a large empty parking lot nearby. Accelerate up to about 20 mph and apply the brakes firmly. You'll need to do this several times, as each time the brakes will adjust a bit each time the brakes are applied. After 15-20 braking events, the brake should be properly adjusted.
Products Referenced in This Question
Brake Adjustment Spoon for Drum Brakes
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- Adjuster
- Brake Adjuster Tool
- Performance Tool
more information >
Product Page this Question was Asked From
etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 12 x 2 Inch Drum
- 5200 lbs Axle
- 6000 lbs Axle
- 7000 lbs Axle
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Video: Review of MORryde Replacement StepAbove Gas Strut - MR56DR
- Q&A: Are etrailer Electric 12" Brakes a Replacement For Dexter 12" Trailer Brakes?
- Q&A: Are The etrailer or Dexter Brakes Going To Be Better For Dexter 6,000LB Axle?
- Video: Review of MORryde RV and Camper Steps - MR29UR
- Shop: Replacement Gas Strut for MORryde StepAbove RV Steps with Strut-Assist - Qty 1
- Shop: Replacement 2 Piece Ball-Stud for MORryde StepAbove Strut Assist RV Steps
- Shop: etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Shop: Dexter Nev-R-Adjust Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 6K
- Search Results: 23~458
- Shop: Electric Trailer Brake with Dust Shield - Self-Adjusting - 12-1/4" - Left Hand - 10,000 lbs
- Shop: etrailer Electric Trailer Brakes w/ Dust Shields - Self-Adjusting - 12-1/4" - Left/Right - 10K
- Search Results: carbon monoxide and propane
- Search Results: 25~742
- Q&A: How to Determine What Generation of MORryde Steps You Have?
- Shop: Electric Trailer Brake with Dust Shield - Self-Adjusting - 12-1/4" - Right Hand - 10,000 lbs
- Q&A: MORryde StepAbove Fold-Down Step Strut Replacement
- Search Results: 12x4
- Video: etrailer Self-Adjusting Electric Trailer Brake Review
- Q&A: How to Measure to Determine the Size Trailer Brakes Needed For Hydraulic Drum Replacement
- Article: Most Popular Wheel Bearings
- Search Results: brakes
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Video: Dexter Nev-R-Adjust Electric Trailer Brake Kit Installation 23-458-459
- Search Results: 23~459
- Article: Trailer Tire Sizing
- Shop: Brake Controller
- Video: Review of Dexter Axle Trailer Brakes - Electric Drum Brakes - 23-458-459
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Shop: Suspension Enhancement
on Trailer Brakes
