Can MaxxFan Deluxe Roof Vent # MA00-05100K Be Installed in Bathroom

Question

Question:

Looking at installing a Maxi Fan Deluxe in my wet bath area. There is a note stating not for use in shower area. Is this installation out of the question or just require extra caution when using water/shower in this location?

asked by: Randy M

0

Expert Reply:

With the MaxxFan Deluxe Roof Vent # MA00-05100K you can install it in a bathroom but you wouldn't want to put it in a dedicated shower room since the moisture level would be so high there.

expert reply by: Jameson C

0

Answer 1

The Multi-Purpose Access Door #SE68VR is designed without a lock so you have easy access to whatever is stored behind the door. There isn't a way to add a lock unless you want to try modifying the door (which you would have to figure out on your…

view full answer...

Answer 2

I contacted Fan-tastic Vent and the Vent cover part #FVU1500WH works with your fan-tastic fan 6600. The fan lid does open to 11-1/2 inches tall and the cover is 10- 1/4 inches so the fan lid does not completely open with the cover attach but…

view full answer...

Answer 3

We contacted Fan-tastic Vent and the Vent cover part #FVU1500WH works with your fan-tastic fan 6600. The fan lid does open to 11-1/2 inches tall and the cover is 10- 1/4 inches so the fan lid does not completely open with the cover installed but it…

view full answer...

Answer 4

Replacement screens are designed to fit specific models of trailer vents, and there isn't an option for one with similar dimensions to yours. Since the company went out of business and there aren't going to be replacements, the only…

view full answer...

Answer 5

The MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat item #MA00-06200K uses up to 5-Amps to operate when running and up to 9-Amps for startup. So probably between 90 - 100 hours if it was the only thing running and you left it on.

view full answer...

Answer 6

There are stabilizer jack handles with a 3/4" socket that have some length to them, but not quite the 16 inches you are looking for; the closest would be the Replacement Handle for Scissor Jacks #BAL-24033. This handle measures 27-1/2" long…

view full answer...

Answer 7

I went out to the warehouse to measure replacement crank handle #TJSC-24-HD. From the tip of the socket end to the first bend it is 13-3/4 inches. The overall length is 27-3/8 inches.

view full answer...

Answer 8

The MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat #MA00-05100K that you referenced runs on 12 volts and draws 5 amps max. If your DC outlet can handle 5 amps then this would work but it would be right at the limit.

view full answer...

Answer 9

That was a problem in older versions of the MaxxFans but the current ones can handle more voltage variances without it causing any problems so you don't have anything to worry about.

view full answer...

Answer 10

Good morning, Don. The 3/4" wide butyl tape is exactly what we recommend for installing a roof vent such as the MaxxFan #MA00-07000K. We actually sell a roof vent install kit part #344270KITW that comes with sealant, screws and a 30' roll of…

view full answer...

Answer 11

Your Dometic 57915.531 is a 13.5k BTU AC unit which the Advent Air RV AC Unit #ACDOM135 is the same size and is also designed to replace Dometic units.

view full answer...