Replacement Hardware Kit for Thule TracRac TracVan Roof Rack

Question

Question:

Good evening! I am interested in the item TAHD-80931, but I need only a few items from the Kit ... do you also sell separate parts? Thank you!

asked by: Mateus F

0

Expert Reply:

I may have a solution for you, but those parts are not sold individually. For that reason, in order to get replacement parts for the TracRac TracVan 3-Bar Van Ladder Racks you do need to purchase the complete hardware kit with the # TAHD-80931. You may only need a few pieces now, but this would provide you with additional mounting hardware if any other parts got lost or were damaged in the future.

expert reply by: Erik B

0

Answer 1

The gutter mounts we have are actually really sturdy if you get the right ones and install them right. Technically, you should have more weight capacity off the gutter mounts since the weight is distributed vertically through the gutters vs racks…

view full answer...

Answer 2

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 6

Hey Alex, it sounds like you are looking for just the tracks of the Rhino Rack camper shell roof rack kit #Y02-480B which we do offer with the part #RTC16.

view full answer...

Answer 7

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 8

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 9

The Tulga T10 D2 5th Wheel Hitch is more for semi-tractor applications and has a pretty big draw-back in that you cannot adjust the hitch head height which is critical for fifth wheel towing because you need to be as level as possible or you will…

view full answer...

Answer 10

Sure can; there are a couple parts you'll need to add a 7-way to your 2023 Chevy Bolt EUV, which are the following: - Tail Light Converter w/ 4-Way Flat Trailer Connector #C59496 - Universal Installation Kit for Trailer Brake Controller #ETBC7…

view full answer...

Answer 11

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

view full answer...

Answer 12

I have a Yakima crossbar setup that is compatible with the Retrax Pro XR Tonneau Cover on your 2021 Toyota Tacoma, however, the Yakima Bedrock is not compatible and the 60" crossbars would be too short anyways. I recommend going with the…

view full answer...

Replacement Hardware Kit for Thule TracRac TracVan Roof Rack

Product Page this Question was Asked From

Continue Researching