Which SumoSprings Solo Fits 2020 Chevy Silverado 1500

Question

Question:

I have a 2020 Chevy 1500 Z71 will the Sumosprings Code#SS45FR fit my Truck

asked by: Robert L

1

Helpful Expert Reply:

Yes the SumoSprings part # SS45MR is a fit for your 2020 Chevy Silverado 1500 Z71.

expert reply by: Jameson C

1

Answer 1

Since the SumoSprings will be helping to support the trailer's tongue weight load, ideally you'll want to match the amount of support offered by the SumoSpring to the trailer's tongue weight. Since at most, the tongue weight…

view full answer...

Answer 2

If a 1000 lb round bale is the heaviest thing you'll haul in the truck bed, I'd recommend going with the SumoSprings #SS95MR that you'd looked at, which would provide you a little bit of leeway in case the bales vary in weight…

view full answer...

Answer 3

I recommend the SumoSprings Solo Custom Helper Springs #SS45MR for your 2015 Chevrolet Silverado 1500. I like this springs over the others that we offer because they're maintenance free and have no tubing to run or air pressure to monitor like…

view full answer...

Answer 4

On GM vehicles of that vintage, the 12-V pin should be hot regardless of whether the ignition is on or not. If it isn't showing voltage even with the ignition on, you're almost certainly on the right track thinking it's a blown or…

view full answer...

Answer 5

It is recommended that you use the included spacer with the SumoSprings kit part #SS45MR that you have installed on your 2018 GMC Sierra 1500. This allows the kit to engage at the appropriate point in your suspension travel to give you the support…

view full answer...

Answer 6

When the SumoSprings Solo Custom Helper Springs item #SS65FR are installed on your 2020 GMC Sierra 1500 you will have a 1/2" - 1" of clearance with no additional cargo weight. This allows for you to have a comfortable ride when you are…

view full answer...

Answer 7

The SumoSprings Solo Custom Helper Springs - Rear Axle #SS45MR are compatible with the MagneRide suspension on your 2018 GMC Sierra 1500. These have a 2,800 lb weight capacity and a microcellular urethane construction. The SumoSprings will be a great…

view full answer...

Answer 8

I checked with Sumosprings and the #SS65FR and the dimensions are 5 inches tall by 4 inches in diameter without the spacer.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Which SumoSprings Solo Fits 2020 Chevy Silverado 1500

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching