Best Way to Lift 2011 Keystone Montana 3100RL  

The diameter of your trailer axle will determine the size of the parts that you will need to order. If your axle is 3 inches diameter, the Dexter Trailer Springs Over-Under Conversion Kit, #K71-385-00, would be a great choice and if your axle is…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Patrick, so for your leaf spring upgrade I am going to need to know a couple of things before I can get you over to the right part. Specifically, the length from eye to eye, the spring width, leaf thickness, and the number of leaves. From here I…

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

The correct replacement for your 1-065-041012-01 motor is part #LC141893 from Lippert. Your original motor had a 7140 rpm speed. The Stromberg-Carlson #LG-196308 you specified has a 5430 rpm output, so it wouldn't be a good choice. You'll…

I have checked the installation instructions for the Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00, and according to Dexter they strongly recommend tack welding the spring seats in place. Please note that this kit is intended for use…

Dexter Trailer Springs Over-Under Conversion Kit, part #K71-384-00, is specified by Dexter for use only with double-eye springs. It is not suitable for use with slipper springs. It is considered by our technical friends at Dexter to be unsafe to use…

First, thank you so much for providing all the axle information on your 2007 Fleetwood Redline 33. The 4-Leaf Double-Eye Spring #e47SR is our closest match to the Lippert 702096 leaf springs that came on your trailer. You will want to order 4 of…

First, thank you so much for providing all the axle information on your 2007 Fleetwood Redline 33. The 4-Leaf Double-Eye Spring #e47SR is our closest match to the Lippert 702096 leaf springs that came on your trailer. Both are 4 leaves and the…

Yes when you do an over-under kit you have to weld the seats to the axle for it to be installed properly. It is recommended to tack weld the new spring seats into place but a complete weld job is not required when installing the over-under conversion…