Availability Of Black 4" - 5" Wide Nerf Bars For 2021 Chevrolet Silverado 1500 LT Crew Cab

Question

Question:

Hello, Im looking for nerf bars for my 2021 Chevrolet Silverado 1500 LT - Crew Cab - 4x4 - 66 bed Im looking for black 4 or 5 inch nerf bars. Preferably round/circle and curved ends, but not necessary. I just dont like the look of silver. Either wheel-2-wheel or doors only. Do you have any suggestions. A few would be appreciated so I can pick thought them.

asked by: Justin B

0

Expert Reply:

For your 2021 Chevrolet Silverado 1500 LT Crew Cab With the 6'6" bed I have a few options that match the criteria you mentioned of 4"-5" width, Black finish, but all of them are cab length as we do not currently have a wheel to wheel option with the 6'6" bed in black.

Starting with the Westin PRO TRAXX Oval Nerf Bars - 5" - Black Powder Coated Steel # 21-54135 these nerf bars are 5" oval with a 5" wide textured step pad giving you a secure place to place your feet even in less than ideal weather conditions.

Moving on to the Westin Platinum Series Oval Nerf Bars - 4" - Black Powder Coated Steel # 21-4135 which are 4" oval tube with 4" wide textured step pads.

Lastly we have the Westin R7 Nerf Bars - 7" Wide - Black Powder Coated Steel # 28-71275 which is a 7" wide rectangle tubing offering you the most area for your feet, but is slightly larger than the sizes you mentioned you were looking for.

All of the nerf bars mentioned include custom fit mounting brackets for a no drill installation on your Silverado.

Personally I like the look of the PRO TRAXX # 21-54135 the most, but I'm sure that between these options you will find one that matches what you had in mind for your truck

I included a picture of the # 21-54135 and a video of the # 21-4135 for you to take a look at.

expert reply by: Samuel C

0

click to enlarge

Answer 1

I attached pictures that I took from the install instructions for the Westin R7 Nerf Steps #28-71275 which fit your 2021 Chevy Silverado 2500 crew cab.

view full answer...

Answer 2

The Westin R7 Nerf Bars item #28-71270 mount to your Silverado without having to drill. The included brackets bolt onto existing holes in your truck's rocker panels. These are confirmed to fit your 2022 Chevy Silverado 2500 crew cab. These bars…

view full answer...

Answer 3

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 4

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 5

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 6

My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…

view full answer...

Answer 7

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Availability Of Black 4" - 5" Wide Nerf Bars For 2021 Chevrolet Silverado 1500 LT Crew Cab

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching