Replacement for Venture Gearbox VMC940RB

Question

Question:

Looking for a replacement gearbox VMC940RB-255298

asked by: David W

0

Expert Reply:

We do have the replacement gearbox you need for your Venture VMC940RB, which is the following part:

- Replacement Gearbox for Venture Aluminum Electric 5th Wheel RV Landing Gear Assemblies # LC276602

I have added a link below to a video review for you to check out as well if you'd like.

expert reply by: Kyle S

0

Answer 1

For your Venture landing gear you can use #LC276602 or #LG-179015. Either one will work.

view full answer...

Answer 2

In case you want to just service your existing Venture VMC940 5th wheel landing gear driver leg you can use gearbox #LG-179015. For a complete replacement lead jack use Replacement Lead Jack with Drop Leg #LG-179013 which is a universal fit that…

view full answer...

Answer 3

We offer two replacement gear boxes that will work in place of your Venture model VMC940RB. You can use either part #LC276602 or #LG-179015. For a compatible electric motor you can use part #LG-196308.

view full answer...

Answer 4

Unfortunately, we do not know what size landing gear you need from your RV information. The RV industry is too inconsistent. This means that you will need to take some measurements and get some information from your current landing gear. You need to…

view full answer...

Answer 5

The Atwood #AT3308046006 cover that you selected will likely work just fine. I contacted the manufacturer and they did not have your model 600315.321 so I can't spec out the exact one. There may be another sticker on your unit ending in .331 or…

view full answer...

Answer 6

The replacement motor you need is the Replacement Motor for Stromberg Carlson Electric Landing Gear, part #LG-142178. The replacement gearbox needed for this motor is part #LG-179015. If you need a switch for this motor, you can use part #LG-145236.

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 10

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement for Venture Gearbox VMC940RB

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching