How are Classic Accessories # 052963762501 RV Wheel Covers Held In Place

Question

Question:

Do your covers incorporate grommets for bungee cords to secure cover to wheel in wind?

asked by: Joe

0

Expert Reply:

The Classic Accessories Wheel Covers you mentioned, part # 052963762501 use an elastic band on the rear of the cover that applies tension, which holds the cover in place. The cover does not have grommets for attaching a bungee cord.

expert reply by: Mike L

0

Answer 1

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

Hey Jeff, The Pace Edwards JackRabbit Retractable Hard Tonneau Cover w Explorer Rails #311-JED7833 is designed for a 6-1/2' bed while the #311-KRD7936 is designed for an 8' bed. Since you have a 6-1/2' bed the #311-JED7833 would be the…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

I believe we have just about everything you need, ideally we'd need you to measure your center bolt and u-bolts to make sure the here will fit. So, for a center bolt you can use the Leaf Spring Center Tie Bolt with Nut #38-3TB which measures…

view full answer...

Answer 7

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 8

The wheel/tire products we sell come from the distributor already mounted together. These wheel/tire items are not dynamically balanced on machinery the way a passenger vehicle tire is because trailer tires do not need to be as well balanced as…

view full answer...

Answer 9

Kenda trailer tires are primarily made in China like most trailer tires. The only Radial trailer tires that I'm aware of that are made in the United States are the Goodyear Endurance line. Carlisle has a bias ply line of tires made in the States,…

view full answer...

Answer 10

Karrier and Loadstar are two different brand names used by Kenda. There's no difference in quality or function between the two brand names. For a ST175/80-13 Radial trailer tire in load range D, I'd recommend part #AM10210 if you're…

view full answer...

Answer 11

For the axle U-bolts, we have two different options: - 3" Round Trailer U-Bolts 9/16" Diameter #SP01-080 - 3" Round Trailer U-Bolts - 1/2" diameter #SP01-060 Since these bolts are so close in diameter, I recommend measuring the…

view full answer...

Answer 12

Any of the Load Ranges you mentioned in your tire size of 205/75R15 would be adequate for your two 3,500 lb trailer axles but I would go with the Provider part #TTWTRTM2057515C which has an 1,830 lb max load weight capacity and has a higher speed…

view full answer...

How are Classic Accessories # 052963762501 RV Wheel Covers Held In Place

Product Page this Question was Asked From

Continue Researching