Single Step Replacement for ETD 728 Elkhart Tool and Die Step
Question:
What can step ETD 728 Elkhart Tool and Die be replaced with? Thanks,
asked by: Jennifer P
0
Expert Reply:
For a single pull out step you could use to replace your ETD 728 Elkhart Tool and Die step you'd want the part # SMFP-1100.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Flexco Manual Pull-Out Step for RVs - Single - 7" Drop/Rise - 24" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 24 Inch Wide Step
- 25 Inch Wide
- 1 Step
- 7-1/2 Inch Drop/Rise
- No Ground Contact
- Steel
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Dimension of Flexco Manual Step # SMFP-1100 When Folded In
- Q&A: Recommended Tie-Downs to Secure Newer Mustangs with Limited Wheel Well Clearance to Trailer
- Q&A: Dimensions for the 10K Demco eZ-Latch A-Frame Trailer Coupler
- Q&A: Can ARK Stabilizer Jacks Rotate 180 Degrees
- Article: How to Raise Your Travel Trailer Height
- Q&A: How to Gain More Height for Trailer With Double-Eye Leaf Springs
- Q&A: Can 3,500 lb Axle of Trailer Be Upgraded to 5,200 lb Axle
- Article: Double-Eye Trailer Suspension System Review
- Q&A: Brophy Aluminum Camper Scissor Bracket Width
- Article: Trailer Hitch Installation Tips
- Article: Top 10 Upgrades for Your Camper
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Maintenance Schedule
- Article: How to Measure for Motorhome Steps