Replacement Converter for Magnetek 6300 in 1999 Windwood

Question

Question:

I have a magnetek model 6345 series 6300a 45amp that went bad. What is a good easy to install replacement for this?

asked by: Phil A

1

Helpful Expert Reply:

You can use the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp # PD4645V you were looking at, which is the recommended replacement for your Magnetek 6300 series converter. This is going to be roughly the same size as your old converter so it will fit in the same space.

I've linked our review video on this part for you to have a look at.

expert reply by: Erik B

1

Answer 1

The Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V is a replacement for your converter. It will work very well based on the cross-referencing for a perfect fit. All converters have a battery charging system…

view full answer...

Answer 2

We offer a direct replacement for your current 45A Parallax/Magnetek 6345 Power Center. The Progressive Dynamics Replacement Converter, part #PD4645V is exactly what you'd need. I've linked to a product description video for the…

view full answer...

Answer 3

For your Parallax/Magnatek 6300A model 6345, I recommend going with the: -Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V. This system has a 45 amp output same as your current model 6345, will work with flooded lead…

view full answer...

Answer 4

For a new converter section for what you have the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade replacement for the Magnetek Converter Series 6300 Model 6332 that you have now. If were…

view full answer...

Answer 5

For a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade replacement for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 6

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

I confirmed with Progressive Dynamics that the replacement part you need is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

The correct part to replace your current converter charger is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 55 Amp part #PD4655V. This is an exact replacement and will be all you need to get back operational. I have…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 12

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…

view full answer...