Replacement 45 Amp Converter for Model 6345

Question

Question:

Need replacement The breakers are melted out from getting to hot. Like where the breakers slot into are gone from getting to hot

asked by: Tanner W

0

Expert Reply:

Thank you for the photo it was definitely helpful. What it shows is you have a 45 amp Parallax/Magnetek model 6345 converter, and we do have the exact replacement you need, which is the following:

- Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp # PD4645V

I have added links below to both the instruction manuals and a video review for you to check out as well if you'd like.

expert reply by: Kyle S

0

click to enlarge

Answer 1

We offer a direct replacement for your current 45A Parallax/Magnetek 6345 Power Center. The Progressive Dynamics Replacement Converter, part #PD4645V is exactly what you'd need. I've linked to a product description video for the…

view full answer...

Answer 2

There is not a direct replacement for your series 6300A model 6325 power converter. The 25 amp converter with 12V power can be replaced with the Progressive Dynamics Inteli-Power RV Converter and Battery Charger - 12V - 30 Amps #PD9130 which will…

view full answer...

Answer 3

In regards to the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4645V, the fused slots on the control board are very easy to hookup. If you're swapping out an old panel just make sure to label each of the…

view full answer...

Answer 4

Yes, you do have the exact right replacement converter for your 45 amp Magnetek 6345, which is the option from Progressive Dynamics: - Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V I have added links below…

view full answer...

Answer 5

The Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp item #PD4135K is the replacement for the Magnetek 6300 Q series RV converter. It comes with the front cover. The AC breakers and DC fuse…

view full answer...

Answer 6

The replacement converter you'd need for your Parallax 7345A is the part #PD4645V. This has all of the same slots for fuses and breakers that you have now so it would work well.

view full answer...

Answer 7

The Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers #PD4645V is exactly what you need for your Magnetek 7300. I reached out to my contact at Progressive Dynamics who confirmed this.

view full answer...

Answer 8

Yes. You can use the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp #PD4645V to replace your Magnetek 7345.

view full answer...

Answer 9

According to Progressive Dynamics, their #PD4645V Replacement 45A converter would be the proper replacement for your Parallax 7345 power converter. The unit is designed as a direct replacement for the converter in your existing power…

view full answer...

Answer 10

To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of battery…

view full answer...

Answer 11

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replacement 45 Amp Converter for Model 6345

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching