Does Valve Core Stay Removed for Firestone Air Bag Kit F4130 When Installed in Air Spring

Question

Question:

4130 Ride-Rite air bag. do I re-sert vale core in top of bag before i put on air line?

asked by: Roger M

0

Expert Reply:

The valve core of the bag in part # F4130 gets removed once the bag is in the air spring and then once the bag is installed and in place you instead thread the fitting on the end of the air line into the bag instead of the valve core you removed.

expert reply by: Jameson C

0

Answer 1

A minimum of 5 psi must be in the air bags at all times, so the rating is measured before the load is on the truck for the Coil-Rite air bags that fit your 2019 Ram 1500, which are the following part: - Firestone Coil-Rite Air Helper Springs #F4130…

view full answer...

Answer 2

We sure do, you'll want to use the Firestone Union Tee for 1/4 inch air tubing, part #F3025-1. This fitting will allow you to inflate both of the air bags included with your #F4130 Coil-Rite kit to the same pressure at the same time using a…

view full answer...

Answer 3

In order to help prevent sag while towing with a 2019 Ram 1500 (4x4 or 4x2) you have a few options, the SumoSprings Solo Custom Helper Springs part #SSR-307-47 or the Firestone Coil-Rite Air Helper Springs part #F4130. The Coil-Rite Springs are…

view full answer...

Answer 4

Yes, the Firestone Coil-Rite Air Helper Springs - Rear Axle #F4130 you were looking at are confirmed to fit your 2021 Ram 1500 as long at it is not the Rebel model and the 1000lb load leveling capacity will do a great job of supporting your rear…

view full answer...

Answer 5

As you mentioned, there are some pretty big differences between a jounce-style spring setup like the SumoSprings #SSR-307-47 and an air bag kit like the Firestone #F4130 for your 2020 Ram 1500, both in terms of install/maintenance and actual…

view full answer...

Answer 6

You've got what's called a Carolina lift and there's nothing I can do for you that'll fix it. The Firestone Coil-Rite Air Helper Springs item #F4130 or any other suspension enhancement won't raise your stock ride height which is…

view full answer...

Answer 7

The big differences between a Class IV and a Class V hitch are the capacities and the opening size. Class IV is going to be a 2 inch hitch opening that has tongue weights typically up to 1,200 lbs and total trailer weight of 12,000 lbs. For a Class V…

view full answer...

Answer 8

The HD air bags from Air Lift part #AL60828HD are thicker material than the non-HD bags which is why you can't slip them between the coils of the rear suspension. Instead you have to push the bag through the top of the coil spring.

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 12

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Does Valve Core Stay Removed for Firestone Air Bag Kit F4130 When Installed in Air Spring

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching