Power Consumption and Efficiency Rating for the Go Power Industrial Sine Wave Inverter

Question

Question:

What is the no load power consumption? Whats the efficiency rating?

asked by: Chuck O

0

Expert Reply:

I spoke with Go Power to confirm these specs for you.

For the Industrial Pure Sine Wave Inverter, part # 34282690, the no-load power consumption is 0.5 amps. The efficiency rating at 12V is 89%.

I've linked to the video review of this inverter for you to look at.

expert reply by: Kef G

0

Answer 1

The valve stem #AM20906 used to only include one grommet that fit the 0.625 hole diameter but now includes both. If it's tight and torqued down properly (Between 25 to 55 inch-pounds technically), the nut will not loosen during travel. Although,…

view full answer...

Answer 2

The Camco garden hose shut-off valve #CAM20073 is designed for non-potable use. I recommend the brass version, #CAM20123, which is NSF/ANSI 61 certified. This is the certification for potable water piping (drinking water). I have linked videos on…

view full answer...

Answer 3

Since the Progressive Dynamics 2000 Watt Inverter w/ Transfer Switch #PD64FR is rated for 30 amps you can absolutely use it with a 30 amp service. For powering all your outlets, that would really depend on the wattage requirements of the appliances…

view full answer...

Answer 4

It sounds like you already have the Bluetooth Remote Display for Go Power MPPT Solar Charge Controllers #GP37MR with the Go Power MPPT Solar Charge Controller #GP72RR. The Remote Display for Go Power MPPT #GP37MR actually uses a bluetooth app as…

view full answer...

Answer 5

It would be a good idea to add a support plate, like #BDSPB50, when installing A-frame jack #BD1550101344. The plate can be welded or bolted on. This plate fits on the underside of the trailer. The jack will then bolt into place. If you need a foot…

view full answer...

Answer 6

Hi John, So we do offer plug-and-play replacements for your Dometic unit, but the options we offer require that you have the same branded controller to plug in a heat strip. This means you would need to replace the entire system in order to have a…

view full answer...

Answer 7

The closest option we'll have to your Atwood 33535E LP/CO2 Detector is going to be the RV Propane Gas and Carbon Monoxide Detector #RS54FR that you were already looking at. It comes with two mounting plates to try and eat up some of your old…

view full answer...

Answer 8

Most trailer jacks like the Lippert #LC285318 only use one wire. That wire provides the power and the assembly grounds through the mounting hardware of the jack. It's hard to tell what's going on with the electric tape and splice connector I…

view full answer...

Answer 9

There was little info about that specific inverter I could find, other than it is a 130 watt inverter. The closest we have to that is a 200 watt pure sine wave inverter, the Go Power Industrial Pure Sine Wave Inverter - 200 Watt - 12V #34282690. This…

view full answer...

Answer 10

A battery disconnect switch (or circuit breaker) is needed for the 400 Watt Go Power Industrial Pure Sine Wave Inverter - GFCI #34282692, but if you want to be able to use it with a remote you will need to get one of the two remotes that work with…

view full answer...

Answer 11

The Go Power Industrial Pure Sine Wave Inverter #34279950 has a power saving adjustment dial near the function switch which sets the input and wake up thresholds for the power saver. You'll simply need to use a Phillips head screwdriver to set…

view full answer...