CIPA CM01139 Adustable Side Mirrors for Kubota 1120D UTV

Question

Question:

I did not see any feedback on the Kubota UTVs. I have an 1120 D.

asked by: Dave F

0

Expert Reply:

I'm not certain what you mean by 'feedback', but the CIPA # CM01139 isn't a vehicle specific item. It will mount to round roll cage tubing that are 1-3/4 inches in diameter. If your roll cage uprights are of that diameter, the mirrors will work great for you.

As you can see from the provided product reviews, this mirror set gets good reviews from our customers.

expert reply by: Mike L

0

Answer 1

Yes, the Dexter brake magnets 071-057-00 and K71-057-00 are the same part and both are for 7 inch brake assemblies. Our replacement magnet is #BP01-068.

view full answer...

Answer 2

The 7 inch Dexter Brake Assemblies like the part #23-48 do use clips to attach the magnets to the assemblies. I went and pulled one from our warehouse and found that in order to attach the magnet to the arm you would need to slide the magnet over the…

view full answer...

Answer 3

Regular "chatter" is not a common problem and since the magnet is damaged I strongly recommend replacing it with the Replacement Magnet Kit for 7" Electric Trailer Brake Assemblies #AKBRKR-M7.

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

I would check the magnets for wear before going on to test them with a meter. If the magnets show abnormal wear or if you can see the windings beginning to show through the friction surface of the magnet then they will need to be replaced. To further…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

You can indeed test a trailer's electric drum brakes by directly applying +12V power from a fully-charged battery. You can apply this power to the hot and ground contacts on the trailer's plug (see photo please) or to an individual brake…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

For your 2015 GMC Sierra 3500 Denali DRW 4x4, I recommend using the Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs part #F2709 over the Air Lift LoadLifter 7500 XL Air Helper Springs part #AL57538 for two reasons. The first reason is…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

CIPA CM01139 Adustable Side Mirrors for Kubota 1120D UTV

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching