Truck Mounted Ladder Rack for 2007 Toyota Tacoma

Question

Question:

Ordered a truck rack MT70423 may be wrong for my 2007 Tacoma need to order one that we fit , was looking at 59799 or can you find correct one in the MT70423 range

asked by: Bob H

0

Expert Reply:

The MaxxTow Truck Bed Ladder Rack MT70423 is not a confirmed fit for your 2007 Toyota Tacoma. The Rola Haul-Your-Might T3 Truck Bed Ladder Rack - Aluminum - 800 lbs # 59799 you referenced is a confirmed fit if your have the Deck Rail System. If you don't have the deck rail system, I recommend the T-Rac Pro2 Ladder Rack for 2005 to 2015 Toyota Tacoma - Fixed Mount - 1,000 lbs # TH37004XT.

expert reply by: Jason S

0

Answer 1

Congratulations on the purchase of your 2009 Toyota Tacoma. The most you will be able to carry with a ladder rack on this vehicle if you have the deck rail system is 800 lbs because that is what the deck rail system limits you to. Therefore, the best…

view full answer...

Answer 2

Thule has the Toyota Tacoma Mount Kit for Thule TracRac TracONE Ladder Rack #TH34000 which it sounds like is what you are needing. This is the bracket set that allows the Thule/TracRac ladder racks to attach to the factory track you have in the bed…

view full answer...

Answer 3

Yes, the Thule TracRac TracONE Ladder Rack for Toyota Tacoma #TH27000XT-TA will allow you to carry 10-foot long heavy loads of lumber up to 800 pounds on your 2008 Toyota Tacoma. The TracONE is constructed of 6000-series aluminum construction that is…

view full answer...

Answer 4

Hey Shannon, thanks for reaching out! Sounds like you're looking for the Thule Xsporter Pro #TH500XTB-THXK3 for your 2008 Toyota Tacoma with the Deck Rail System. This is adjustable up and down as well as along the Deck Rail System so you get the…

view full answer...

Answer 5

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 6

Hey Angela, If you're wanting a ladder rack then I recommend the Thule TracRac TracONE Ladder Rack #TH27000XTB-TA. This rack comes with load stops that you could use to secure your paddleboards or you could go with a track mounted carrier like…

view full answer...

Answer 7

Yakima's Skyline towers part #Y53TR can fit the tracks of the Retrax XR that you have with the landing pad 1 part #Y00221 but there isn't a way with the Baseline towers. Your Yakima Corebar or Jetstream bars will work with the Skyline towers…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 11

The mounting holes on the Curt 5-Position Adjustable Channel Bracket #C48650 measure 10" center of hole to center of hole.

view full answer...

Answer 12

The Rhino Rack ROC25 part #RR46XR has a 165 lb dynamic weight capacity which means that's how much it can carry while travelling and incurring the standard bumps and movement that creates. While Rhino Rack doesn't give a static weight…

view full answer...

Truck Mounted Ladder Rack for 2007 Toyota Tacoma

Products Referenced in This Question

Featured Help Information

Miscellaneous Media

Continue Researching