Will the Rhino-Rack Ski and Fishing Rod Carrier Work With a Ladder Rack

Question

Question:

Can you tell me the distance between the 2 mounting points on this ski rack? I have a unique application for this rack as I want to attach it to a ladder on my truck camper but the mounts may be too far apart for it to fit.

asked by: Mark

1

Helpful Expert Reply:

The Rhino-Rack Ski and Fishing Rod Carrier part # RR572 will work with crossbars up to 3-3/4" wide x 7/8" tall with the factory hardware. If you were to substitute the factory hardware that comes with for something longer it would fit taller crossbars but there would be no way to expand beyond the width of 3-3/4".

expert reply by: Conner L

1

Answer 1

Yes, the Yakima ReelDeal Rooftop Fishing Rod Carrier, #Y04089 will work with the Thule AeroBlade. I have attached a product review and installation video below, please jump to about the 5 minute mark where it begins discussion of installation and…

view full answer...

Answer 2

The Rhino-Rack Ski and Fishing Rod Carrier #RR572 can mount to roof rack crossbars in two ways, with the included universal-fit clamps that let it attach to almost any type of roof rack bar, and also with the T-Bolt hardware that slides into the…

view full answer...

Answer 3

Glad you like the Yakima ReelDeal Rooftop Fishing Rod Carrier #Y04089. This clamshell style has a thick rubber portion to conform around the rods and can be used for ski's and snow boars as well. The measurement from the top of this rubber piece…

view full answer...

Answer 4

The crossbar spread often referred to with roof boxes like #TH6359B or other accessories is measured from center to center. By measuring from the center of the bar to the center of the bar you will get the crossbar spread required for a roof box.…

view full answer...

Answer 5

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 6

Hey Tim! Yes, the Rhino-Rack Ski and Fishing Rod Carrier #RR572 will fit the older Thule square crossbars. While this kit does come with T-Slot hardware, it also has the clamps which is what you'll use for the square crossbars.

view full answer...

Answer 7

Yes, the Rhino-Rack Ski and Fishing Rod Carrier #RR572 that you referenced does fit the Whispbar crossbars you have. The picture I attached shows the carrier installed on a similar set of aero crossbars.

view full answer...

Answer 8

The best Timbren kit for your 2024 Toyota Tundra is the Timbren Suspension Enhancement System #T45MR rated for 6K. The Off-Road kit and the 7K kit will have the Timbren bumpers engaging a bit quicker than what you'll need with standard vehicle…

view full answer...

Answer 9

While we do have some T-Bolts #RR72XB which will fit into the TS Rails for TruXedo Elevate Rack System #TH65FR. I recommend using the hardware which comes with the Tie-Down Kit #TH52FR since the kit comes with 8 T-Bolts as well as washers and nuts.…

view full answer...

Answer 10

From the sounds of your question, it sounds like you have factory track OEM rails on the roof of your 2015 Jayco 1207UD Say Series camper. If this is the case, I recommend the following parts: - Rhino-Rack Roof Rack for Factory Tracks - 2 Vortex Aero…

view full answer...

Answer 11

The Rhino-Rack Ski and Fishing Rod Carrier #RR572 would be a great choice to carry your surf rods. It clamps on to round, square, aero, elliptical, and most factory crossbars and has a push-button release so you can open it easily. I've attached…

view full answer...

Will the Rhino-Rack Ski and Fishing Rod Carrier Work With a Ladder Rack

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching