Will the Hopkins Custom Tail Light Wiring Kit for Towed Vehicles Fit my 2015 Jeep Wrangler Rubicon

Question

Question:

will the HM-56200 fit my 2015 Jeep Wrangler Rubicon

asked by: Michael M

1

Helpful Expert Reply:

Yes the Hopkins Custom Tail Light Wiring Kit for Towed Vehicles part # HM56200 is a custom fit item designed to fit your 2015 Jeep Wrangler Rubicon.

Check out the installation video I linked for you.

expert reply by: Randy B

1

Answer 1

For tow bar wiring for your 2012 Jeep Wrangler Unlimited you have a few options. I attached an article to the right that details how to select the correct tow bar wiring based on your needs. The option I like the most because of how easy it installs…

view full answer...

Answer 2

With the caveat that we don't carry Mopar wiring and as such aren't familiar with it, there should be a way for you to do this. There isn't an adapter to connect the female 7-way on your Jeep to the female 6-round on the Roadmaster…

view full answer...

Answer 3

My technical contact at Roadmaster advised that there are two potential causes for the red light to remain lit on your Even Brake #RM-9400. One possibility is that the unit is too close to the brake pedal and is pressing it. The other possibility he…

view full answer...

Answer 4

It sounds like you may have some circuit bleed through, and is not a problem since the LEDs on the Roadmaster Nighthawk #RM-676 take hardly any amperage to operate. If you want it to go away, you can just unplug the tow bar lighting from your Jeep…

view full answer...

Answer 5

The RoadMaster Even Brake System is connected to your Suzuki (towed vehicle) battery for power. The engine does not need to be running for the battery to provide voltage and power to the brakes. (Even Brake consumes battery power in the towed car as…

view full answer...

Answer 6

From what I have found in my research, to flat tow the vehicle the ignition key must be turned to the first or accessory position. Even with all accessories in the vehicle switched off, this creates sufficient draw on the battery to discharge the…

view full answer...

Answer 7

So LED diodes do not take much amperage at all to activate. If there's any circuit bleed through on the circuit the LED will partially light up. This is why the lights of the Roadmaster Nighthawk All Terrain #RM-676 are activating partially. It…

view full answer...

Answer 8

The Roadmaster D-Ring adapter part #RM-035 will fit on the Roadmaster Nighthawk #RM-676 tow bar that you also referenced.

view full answer...

Answer 9

It is completely normal for one of the pins on the Roadmaster Nighthawk All Terrain, Non-Binding Tow Bar w/ LED Lights #RM-676 - or any tow bar, really - to be more difficult to remove. The reason is the amount of force on a tow bar, both when…

view full answer...

Answer 10

The Roadmaster Nighthawk, part #RM-676, is one of the nicest tow bars on the market. The tow vehicle will track right behind the vehicle as you are traveling. Since the front wheels of the vehicle will be unlocked the vehicle will steer itself in the…

view full answer...

Answer 11

It really depends on the vehicle you are flat towing using a tow bar like the Roadmaster Nighthawk #RM-676 that you referenced as to whether or not the odometer will track the mileage. Late/current model vehicles typically have an electronic dash…

view full answer...

Answer 12

The measurement you are asking for on the RM-676 Road Master Night Hawk Tow Bar with LED Lights, #RM-676 is 13". This is measured from the pivot point where the tow bar tilts 90 degrees for storage mode to the pin hole on the stinger portion.

view full answer...

Will the Hopkins Custom Tail Light Wiring Kit for Towed Vehicles Fit my 2015 Jeep Wrangler Rubicon

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching