What Size Drain Tubes Does the Replacement Drain Tube Kit for Retrax Hard Tonneau Covers Use

Question

Question:

Retraxpro drain tube size?

asked by: Brett

0

Expert Reply:

The Replacement Drain Tube Kit for Retrax Hard Tonneau Covers part # RE64FR use 1/2" drain tubes.

expert reply by: Conner L

0

Answer 1

I did see the review saying they used spacers, though that is the only time we have ever come across this, so I wouldn't say yes, spacers are going to be needed to use the Rhino-Rack system, which is the following part number: - Rhino-Rack Vortex…

view full answer...

Answer 2

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 3

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Your 2024 Chevrolet Silverado 3500 will come with a 2-1/2" trailer hitch receiver. If your truck did not come with a reducer for a 2" receiver we do have the B&W #BWRHXA2182 if you need to use your 2" ball mount or hitch mounted…

view full answer...

Answer 6

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the jack…

view full answer...

Answer 7

I have a couple options for your Carolyn. The first is to replace your current side rails with the XR Rails #RTT-82381 on the Cover #RTX37VR so you will have the T-Slots. Other wise using a reack like the Adarac #A54KG would be an option as this…

view full answer...

Answer 8

The Dometic Ultra Breeze Trailer Roof Vent Cover part #DMC38FR installs using brackets which secure to the vent lid flange. The brackets are screwed into the roof but the cover is attached to the bracket using pins and is easily removeable. I have…

view full answer...

What Size Drain Tubes Does the Replacement Drain Tube Kit for Retrax Hard Tonneau Covers Use

Product Page this Question was Asked From

Continue Researching