Trailer Jack for Log Splitter that is Easier to Roll Around

Question

Question:

I purchased a Champion 34 ton log splitter from Home Depot. It did not come with a wheeled trailer jack. I need one to raise the splitter since it is too heavy for me to lift the tongue close to 600 pounds. What do you recommend as a wheeled trailer jack that will also serve for pushing it into our barn?

asked by: Steve

0

Expert Reply:

A dual wheel trailer jack like the Fulton part # FXPD15L would be your best option as it has the capacity you need and since it has two wheels it would roll a little easier.

expert reply by: Jameson C

0

Answer 1

One option is to use a rack and gear jack for A-frame trailers, #BD165412. But in order to get a retracted height under 6 inches the wheel would have to come off. This is because the retracted height is 7-1/2 inches. There are other A-frame jacks to…

view full answer...

Answer 2

I wasn't able to get a CAD drawing for the Fulton Bolt-Thru Swivel Marine Jack #FXPD15L that you referenced (manufacturer's don't typically make those available), however I did go out to our warehouse to take a few measurements on the…

view full answer...

Answer 3

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 4

My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…

view full answer...

Answer 5

I have added a photo detailing the wiring connections for the Pollack Heavy-Duty, 7-Pole, Round Pin conncetor, #PK11700, see link. This is a SAE J560 compliant connector. The wiring diagram for the vehicle side connector, #PK11720, is pictured also.…

view full answer...

Answer 6

We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…

view full answer...

Answer 7

I looked up pictures of the taillights that are on the 3110 Featherlite trailers and for the LED version of them you would want the part #STL36RB and #STL37RB. It looks like the spare tire mounts for your trailer are something you would have to get…

view full answer...

Answer 8

That is an excellent question and is asked more often than you think. Electric brakes like what come in the Electric Trailer Brake Kit #AKEBRK-2 can be submerged in water when you are loading/unloading your boat. Since water and electricity don't…

view full answer...

Answer 9

I'm assuming your Express doesn't have the 7-way, but does have the capped round plug behind the bumper on the drivers side frame rail, you'll install part #30955. Simply remove the cap and plug the connector in. To wire up the controller…

view full answer...

Trailer Jack for Log Splitter that is Easier to Roll Around

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching