Propane Tank Holder for Single 20 lb Propane Tank

Question

Question:

I cannot seem to find a sturdy holder for a single tank. Do you sell one?

asked by: Teresa P

0

Expert Reply:

We do have one option for holding a single 20 lb propane tank, which is from Stromberg Carlson.

- Single-Bottle Liquid Propane Gas Rack # 2020-JR

I have added a link below to a video review for you to check out as well.

expert reply by: Kyle S

0

Answer 1

It sure can. The #2020-JR propane tank bracket is strong enough to support a full 20 lb propane tank. It's not necessary to set it on the floor. This assumes that the surface you attach the rack to is capable of supporting the weight of the tank…

view full answer...

Answer 2

To add a class III hitch to your 2024 Honda CR-V hybrid, I recommend the Curt Trailer Hitch item #C13397. This hitch is custom fit and bolts to your CR-V with included hardware. It is a class III hitch with a 2" receiver. I really like this…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hello Gaby. I reached out to the manufacturer and found out that the UltraFab Weld-On Jumbo Steel Roller #UF48-979023 uses a 6-1.0mm Zerk fitting. For a replacement you can use the following: - Replacement Brass Grease Zerk for Weld-On Hinges - 6 mm…

view full answer...

Answer 5

Yes, we have since been able to confirm the etrailer Trailer Hitch Receiver part #e98848 will fit a 2021 Honda CR-V Hybrid after some confusion early on. There have been multiple reviews from our customers stating it was compatible. I have attached a…

view full answer...

Answer 6

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...

Answer 7

If your switch is illuminated then I do believe that 3rd terminal is for the backlight. For a replacement I recommend checking out the Single Rocker Switch - 12V - On/Off - SPST - Black Plate with Red Illuminated Switch #37212525. Attached is a…

view full answer...

Answer 8

I have a solution for you because as you know what you have now cannot charge Lithium batteries. You will need the Progressive Dynamics #PD4135K which is designed to replace your WF-8735P and is compatible with Lithium batteries. When this is…

view full answer...

Answer 9

We do have replacements for a Coleman Mach Air AC. There are a couple of options for 13,500 Btu or 15,000 Btu units in either Black or White: For black you will want the Advent Air Replacement RV Air Conditioner for Coleman Setup - 15,000 Btu item…

view full answer...

Answer 10

The light that indicates that the 12 volt circuit is hot is normal and it will not drain the battery. Think of it as the battery having a really long positive terminal that just extends to the rear of the vehicle. If nothing is drawing power from it,…

view full answer...

Answer 11

If the vent fan you have now is reversible then there should be a button on the assembly next to the other controls. However, if the fan is not reversible then all you need to do is reverse the wires on the motor (not the circuit board) and that will…

view full answer...

Answer 12

Sure thing! The MaxxFan Roof Vent w/ 12V Fan #MA00A04301K is actually exhaust only. However, if you're wanting the exhaust & intake version, then you'll want the: -MaxxFan Plus Roof Vent w/ 12V Fan and Thermostat #MA00-04000K.

view full answer...