Can The Wave 3 Heater Be Recess Mounted On A Wall

Question

Question:

Can the wave 3 heater be recessed partially into a wall like the model 6?

asked by: Gary P

1

Helpful Expert Reply:

The Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs Item # CAM57331 is designed to be wall mounted due to the size of the unit.

expert reply by: Shane H

1

Answer 1

I reached out to my contact at Camco regarding the Olympian Wave 3 Catalytic Safety Heater #CAM57331 and he said the heater requires at least 4" of clearance on each side and at least 30" of clearance from the front of the unit…

view full answer...

Answer 2

I checked with Camco, and the clearances are the same; you will need 4 inches of clearance on the sides, 18 inches of clearance on top, and 30 inches of clearance in the front for the Camco Olympian Wave 6 Catalytic Safety Heater for Mid-Sized RVs…

view full answer...

Answer 3

Yes. The Camco Olympian Wave Heater #CAM57331 can be used as your primary source of heat and can be setup to be both permanently installed or portable. This is a heating solution that is safe to sleep with the unit on, but you will need to leave a…

view full answer...

Answer 4

We have just what you need, the Go Power Portable Solar Panel with Digital Solar Controller, #34282610. This lets you place the solar panel where you need it for maximum sunlight while not having to place the camper in the sun too. For the later…

view full answer...

Answer 5

The Tekonsha Prodigy P3 Brake Controller, #90195, does not have an on and off switch. It will go into sleep mode after several minutes of no activity. The power draw when it is in the sleep mode is so negligible that it will not discharge the…

view full answer...

Answer 6

Actually to install the Prodigy P3 Brake Controller part #90195 in your 2007 Chevy Tahoe you don't need an install adapter. There are 4 blunt cut wires under the dash that will allow you to wire the controller directly to your vehicle. GM did not…

view full answer...

Answer 7

Catalytic heaters like the #CAM57331 Wave 3 do indeed put out moisture as a byproduct of the heating process, it's unavoidable with that type of heater. After doing some research, I've found that the best bet to keeping a large part of the…

view full answer...

Answer 8

In regards to the Camco Olympian Wave 3 Catalytic Safety Heaters like part #CAM57331, Camco states that the space in which the heater is used must have sufficient airflow to allow for a complete burn of the gasses. In the owner's manual for the…

view full answer...

Answer 9

The distance between the left and right mounting holes on the back of the Camco Wave 6 heater, part #CAM673541 is 9.65 inches.

view full answer...

Answer 10

The Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs #CAM57331 can heat a larger area (120 square feet) compared to the Little Buddy Heater which claims 95 square feet, has a built in automatic Piezo-electric spark starter which will last…

view full answer...

Answer 11

In regards to the Camco Olympian Wave 3 Catalytic Safety Heater for Small RVs part #CAM57331, it must be used in a ventilated area per the manufacturer to prevent the build-up of gasses. That said, its not possible to give specifics on this as there…

view full answer...

Answer 12

You cannot use an adjustable regulator with the Camco Olympian Wave 3 #CAM57331 since this heater operates on a low pressure gas system and running high pressure gas through it would cause it to function improperly and potentially create a dangerous…

view full answer...

Can The Wave 3 Heater Be Recess Mounted On A Wall

Product Page this Question was Asked From

Continue Researching