Recommended Custom Bracket Kit, Base Rails and 5th Wheel Hitch for 2007 Ford F-250
Question:
Bought a used 2007 F350 Crew Cab Long Bed. It has brackets installed, but I dont know what specific brackets they are. Need to get rails and hitch at least. We are planning to pull a Sabre 320FQDS RV. Not sure where to start!
asked by: Michael Y
Expert Reply:
I do have a solution for you, but we do strongly advise not mixing brackets and rails from 2 different manufacturers. The reason for this is that they haven't been tested together, so compatibility and fit cannot be guaranteed and the capacity of the setup will be unknown.
With that said I recommend using the Curt # C16448-204 base rail and bracket kit which will provide you with a set of industry standard base rails to mount a 5th wheel hitch in. These are a custom bracket kit so it'll install to the holes that are already in the frame, so it's going to install with minimal drilling required. Once you've gotten the new bracket and rails installed, you can use the Curt A16 # C16120 that you were looking at. The Curt A16 has a 16000-lbs capacity which is a good fit since it appears that the Sabre 320FQDS has a GVWR of around 11500-lbs. This hitch also fits in the industry base rails that you're installing, so it's a good solution for towing your new 5th wheel hitch.
I've linked some review and installation videos of these parts for you to have a look at, as well.
Products Referenced in This Question
B&W Companion 5th Wheel Trailer Hitch - Dual Jaw - 20,000 lbs
- Fifth Wheel Hitch
- Fixed Fifth Wheel
- Aftermarket Below Bed Rails
- 5000 lbs Vertical Load
- 20000 lbs GTW
- Double Pivot
- Standard - Double Jaw
- 16-1/4 - 18-1/4 Inch Tall
- B and W
more information >
Curt Custom Fifth Wheel Installation Kit for Ford - Carbide Finish
- Fifth Wheel Installation Kit
- Custom
- Above the Bed
- CURT
more information >
Product Page this Question was Asked From
Curt A16 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
- Fifth Wheel Hitch
- Fixed Fifth Wheel
- Above Bed Rails
- 4000 lbs Vertical Load
- 16000 lbs GTW
- Cushioned Double Pivot
- Standard - Double Jaw
- 13 - 17 Inch Tall
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Do all Fifth Wheel Rails have the Same Dimensions
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: How Much Upward Bend Should Trailer Axle Have
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper
- Q&A: Replacement For Dexter DX12.5 Brake Actuator on Boat Trailer
- Q&A: Which Lift Kit Fits 2010 Forest River R-Pod 172 with Lippert 3,500 Torsion Axle
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Gooseneck to 5th Wheel Adapters
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
Michael
8/25/2020
Bought a used 2007 F350 Crew Cab Long Bed. It has brackets installed, but I dont know what specific brackets they are. Need to get rails and hitch at least. We are planning to pull a Sabre 320FQDS RV. Not sure where to start!