Which Air Lift Kit Fits 2006 Class C E450 Jamboree 31m

Question

Question:

Airlift spring kit for my 2006 Ford e-450 31m Fleetwood Jamboree what kit do I need

asked by: Ron R

0

Expert Reply:

There are two kits that fit your 2006 Fleetwood Jamboree 31m but you need to check out the frame of your motorhome to determine which is correct. If there are supply lines on the outside of the frame you'd want part # AL57131 or if they are on the inside part # AL88242 is what you'd need.

expert reply by: Jameson C

0

Answer 1

The #AL88242 is designed to fit the E-450 and has a slightly different mounting process with different brackets. Since your 2015 Thor Vegas 24.1 is on the E-350 chassis you want to use the #AL88138. Since we do not have a specific fit for the Thor…

view full answer...

Answer 2

The Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers - Rear Axle #AL88242 you were looking at is confirmed to fit your 2004 Ford E-450 24' Chateau Class C motorhome as long as the distance between the frame and…

view full answer...

Answer 3

We have an Air Lift air bag kit that fits your 2015 Thor built on a Ford E-450 chassis that has the internal jounce bumpers with the part #AL88242 like the kit you mentioned which would work great.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Answer 10

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 11

We've got a couple options for Air Lift kits that will a 2002 Ford E-450 chassis. Which one you need will depend on where the supply lines are ran on the frame. Both kits have a 5,000 lbs load leveling capacity. I have listed them below: Outside…

view full answer...