Solution to Go From Coiled 4-Way to 6-Way Round for Tow Bar Wiring
Question:
See picture please. The vue has 4 pin port, but the camper has a 6 pin port. Is there an adapter that I need? This car came to us set up with hitch and wiring and was pulled behind a class C. Our class C was used to pull a different vehicle by previous owner.
asked by: Joyce B
1
Helpful Expert Reply:
While there isn't an adapter for the wiring situation you are in you can easily cut off the 4-way round of your coiled adapter and install a 6-way plug in it's place with part # PK11604.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Pollak 6-Pole, Round Pin, Trailer Wiring Connector - Trailer End
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Continue Researching
- Q&A: Recommended Flat Towing Parts for a 2024 GMC Canyon Denali
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Master Cylinder And Shock For UFP A-60 / A-75 / XR-84 Surge Brake Actuators
- Article: How to Choose a High-Low Adapter
- Q&A: Replacement Studs for RVD-H-865 7k Hub/Drum
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Tail Light For Bargman 6-1/2 Inch Oval Light
- Q&A: Bearings and Seal Used for AL-KO 7290 Trailer Hubs for #99 Spindles
- Q&A: Can Sway Control Be Used on a Trailer that Uses a Pintle Hitch Set Up
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch