Block included with the Handle Nut Assembly?

Question

Question:

Does this include the block as well?

asked by: Jeff P

0

Expert Reply:

No, the block (or spacer) does not come with the handle nut assembly. If you are needing the block and other hardware, you might consider looking at the replacement hardware kit for your particular hitch. I have included an excellent video below on how handle nuts work and a link to order a replacement hardward kit, in case you would rather have the whole kit.

expert reply by: DeAnne T

0

Answer 1

The Buyers Products 5/8" Forged D-Ring With 4-Hole Integral Mounting Bracket #337B40MP that you referenced has a 6,130 lbs working load limit which would easily be enough for a Jeep rock crawler. Especially when you consider that…

view full answer...

Answer 2

Yes, you can get replacement hardware kit #RHK which will replace all the hardware for the hitch. Just enter the hitch number where indicated on the page and our team of hardware ninjas will compile the proper kit.

view full answer...

Answer 3

The Draw-Tite Handle Nut Assembly, part #1332 is a 1/2 inch nut that is welded to a handle. It does not include a bolt. I am including a link to a video that will show how the handle nut works. If you are needing the bolt and other hardware, you…

view full answer...

Answer 4

We have just what you need. If you type RHK in the search box on our website it will take you to the replacement hardware kit product page. You will then simply type the number of the hitch you need hardware for in the box that is labeled Hitch…

view full answer...

Answer 5

All of the three brands of Class I hitch offered for your 2011 Honda Civic will require some degree of modification to at least some vehicle components. All available hitches can be seen on the link provided. Among the three hitches offered, the…

view full answer...

Answer 6

In the attached installation instructions for the Draw-Tite Max-Frame Trailer Hitch Receiver #75784 you can find the torque specs directly under step 4. Sometimes the manufacturers will slightly change some hardware to accommodate a wider range of…

view full answer...

Answer 7

For your 2008 Acura RDX, we have the 1-1/4" Curt Hitch #13536 that is confirmed to fit . Also, Curt requires the use of a stabilization strap, like part #18050, when carrying any non-trailer loads such as a bike rack or cargo carrier. If you…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

The Hellwig Adjustable Big Wig Rear Anti-Sway Bar #HE94FR is only going to leave a few inches between it and the spare tire, as you can see in the attached picture. Depending on how far forward you have the tire it could potentially interfere with…

view full answer...

Block included with the Handle Nut Assembly?

Products Referenced in This Question

Continue Researching