Can MaxxAir MA00-07500K RV Roof Vent Fan Be Tested Using Car Battery

Question

Question:

Hi, I don’t have my solar system installed yet. However, I have the fan installed and would like to test to make sure it works before I waterproof it with silicon and Lap sealant. Can i use my car battery to test maxxair fan? Just by connecting the positive and negative via jumper cables?

asked by: Daniel C

1

Helpful Expert Reply:

That's exactly how I'd do it. The # MA00-07500K fan/vent is 12V DC powered, so a car battery would indeed do the trick. I've linked to an installation video for you.

expert reply by: Mike L

1

Answer 1

When installing the MaxxFan Roof Vent #MA00A04301K that you referenced you will want to use butyl tape on the vent edges in addition to the sealant that you will apply around the unit to cover up bolt holes and any other areas that might lead to a…

view full answer...

Answer 2

The fan of the MaxxAir MaxxFan Trailer Roof Vent w/ 12V Fan - w/ Rain Cover #MA00-06200K draws 5 amps. In theory a 750 amp battery would power this for 150 hours.

view full answer...

Answer 3

The MaxxFan Deluxe Roof Vent w/12V Fan measures only 5" tall when closed. Attached is a diagram of this measurement as well as an installation video for you to check out as well.

view full answer...

Answer 4

The MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-06401K only draws 5 amps so you don't need to go crazy with the wiring gauge but I would still recommend 10 gauge like part #10-1-1 (sold by foot) as it's heavier than you'd ever…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 9

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 10

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better…

view full answer...

Answer 11

While I have no way to see exactly what leveling system you have on your 2006 Tiffin Phaeton 35DH, I was able to find information on a forum showing someone who did confirm the SnapPad HiWay 10 Jack Pads for HWH and Atwood Leveling Systems w/…

view full answer...

Answer 12

You will not need any extra parts to wire either the Dometic FanTastic Roof Vent #FV803350 or #FV807350 in place of your current fan. The MaxxFan Deluxe Roof Vent #MA00-07000K would be the route I would go thanks to its additional features. No…

view full answer...

Can MaxxAir MA00-07500K RV Roof Vent Fan Be Tested Using Car Battery

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching