Replacement Jack for Lippert Level Up Hydraulic System on Gulf Stream Friendship

Question

Question:

Can you tell me if the LC26FR is a direct swap part for the passenger side rear Hydraulic Leveling Jack of my 2004 Gulf Stream Friendship G7?

asked by: Al M

0

Expert Reply:

As long as your 2004 Gulf Stream Friendship G7 has the Lippert Level Up Hydraulic leveling system the part # LC26FR is the correct replacement jack for it. I don't have a way to look up what your RV may have or had installed later so I can't tell you directly.

expert reply by: Jameson C

0

Answer 1

It sounds like you are looking for a replacement Lippert hydraulic leveling jack. We have several options that you can see at the attached link. I would recommend getting the part number of the jack you have and I'll help you pick out what you…

view full answer...

Answer 2

Only solution would be with a new leg like part #LC26FR as the seal for your jack is not available.

view full answer...

Answer 3

Ok for hydraulic jacks that have a mind of their own you will need to do a bypass test first. Retract jack in question. If retracting hydraulic landing gear, HLG, both jacks will retract. If retracting leveling jack, all jacks will retract. Once jack…

view full answer...

Answer 4

Yes. You've found the right part. The 29/324 378 part number you've referred to off your existing jack corresponds to the Lippert Replacement Level Up Hydraulic Jack - 8,000 lbs - 15" Travel #LC26FR so it will be the correct replacement…

view full answer...

Answer 5

Yes, as a matter of fact we have just what you need. The Replacement Hydraulic Jack Assembly for Lippert Level Up System #LC99ED is the Lippert 236560 part you mentioned. This jack has a maximum weight capacity of 14,00lbs, and measures 21-7/8"…

view full answer...

Answer 6

We do carry some Lippert Hydraulic jacks but none by those part numbers. I tried looking them up on Lipperts site and found nothing on the 2571254 number and the 25712510 seems to have been superseded by a jack with a 14,000 lb. capacity, but not one…

view full answer...

Answer 7

If your 2013 Crusader 295RST has the Lippert Components Level Up jack system on it currently then yes the replacement jack part #LC26FR would work as a replacement for it but if you have something else you would need to go a different route and would…

view full answer...

Answer 8

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

I spoke with my contact at Pollak and he stated that the Pollak Replacement 7-Pole, RV-Style Trailer Connector Socket, #PK11893-11933 is the correct replacement part for the Pollak PA66-MD40 that you have.

view full answer...

Answer 11

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 12

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Replacement Jack for Lippert Level Up Hydraulic System on Gulf Stream Friendship

Continue Researching