Replace Lost Key For Yakima Swingdaddy Bike Rack

Question

Question:

Hi. I lost my lock key to my Yakima Swingdaddy bike rack its and old model bike rack, how can I get a replacement key? I dont know what key number it was.

asked by: Gregorio P

0

Expert Reply:

I have a Solution for you. Without the key number you will need to replace the lock core because Yakima offers a large amount of key configurations. This can be done very easily with Yakima's Same Key System Set # Y07202. The "master key" will allow you to remove the lock core and insert a new one. This will only work if your original lock is unlocked. If it is locked you will need to contact your local locksmith to unlock it and then proceed with the Same Key System Set.

The replacement SKS Lock Core fits your Swingdaddy. This set comes with two locks and two keys for other accessories or to use as spares.

expert reply by: Zach D

0

Answer 1

The Yakima LockUp Hitch Lock and Cable Lock Item #Y07238 appear to be the same as its counterpart on the Yakima site SKU: #8007238. In regards to a red piece at the end of the lock the Yakima DeadLock Hitch Lock and Integrated Locking Cable has been…

view full answer...

Answer 2

Once the rack is locked into the receiver, the end of the cable with the loop is passed around the shank of the rack near the receiver. Then the end of the cable with the locking tip is passed through the loop, and the cable is pulled snug. The…

view full answer...

Answer 3

I spoke with Yakima and they informed me that the part you are looking for has been discontinued and is no longer available for purchase. There is also not a direct replacement either but they did say the Replacement Hitch Bolt and Clip for Yakima…

view full answer...

Answer 4

I sent your photo in to Yakima and they confirmed it is the Yakima Terrafirma 4-bike rack, which was discontinued 15 years ago and is model 8002576. They told me the threaded attachment bolt that works is Replacement Hitch Bolt and Clip #Y8890200;…

view full answer...

Answer 5

Since you lost the keys to your locks on a Yakima bike rack like the FullTilt and don't know the key number, what you will actually need to do is replace the lock cores. So long as your rack is currently unlocked, you can simply swap out your…

view full answer...

Answer 6

Yakima won't keep the records for your lock number. If you have an unlocked system then you will simply need the control key #Y8007835 to remove the cylinder. Once removed the cylinder will have a number on the side, that will let you know what…

view full answer...

Answer 7

If you cannot remember what the number on your key was then you will need to contact a locksmith to come and drill out the lock for for you since there is no way to determine what they key number you need is unless you wrote it down before you lost…

view full answer...

Answer 8

It's hard to see in the picture if the lock assembly is damaged, but if the housing is okay you could install a new core with the part #Y07202. Seeing the core drilled out like that does warrant some questions though...like was the box stolen?…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replace Lost Key For Yakima Swingdaddy Bike Rack

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching