What is Replacement Self-Adhesive M5 Washer Made Of

Question

Question:

Im looking to confirm what type of material the following washer is made of: Replacement Self-Adhesive M5 Washer for Thule 54 Top Track System Item # 853-5367

asked by: Dan G

0

Expert Reply:

The Replacement Self-Adhesive M5 Washer for Thule 54" Top Track System # 853-5367 is a nylon washer.

This is a replacement part for the Thule Roof Mounted Top Rack System - 54" Long # THTP54.

expert reply by: Kyle S

0

Answer 1

Even older cargo box mounting hardware will be compatible with a range of roof rack crossbar types. The Thule Atlantis TH685XT uses the claw-type mount #TH05738, as you noted, and it will mount to most crossbars spaced apart 24- to 42-inches. If…

view full answer...

Answer 2

The Thule replacement quick grip mount assembly, part #TH05738, is the correct replacement hardware for your Thule Atlantis 1200 roof cargo box. See diagram to the right. The Thule quick grip mount #TH05738 will also work on Thule 1600 and 1800…

view full answer...

Answer 3

Tracks can absolutely be installed on the roof of your A.R.E. Truck Cap to provide a mounting system for a roof rack. For this I recommend the Yakima Tracks, which come in 42 inch #Y01126, 54 inch #Y01127, and 60 inch #Y01135 lengths. These tracks…

view full answer...

Answer 4

Yakima tells me that the Cap Nut hardware could be used with the #Y01135 on your application, but keep in mind these systems aren't meant for hard-core off-road use. I've provided a photo of the installation instructions.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 7

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Thanks for reaching out, Joe! I recommend using the Rhino-Rack Aero Bar Roof Rack for Camper Shells #Y02-480B which comes with 63" long tracks as well as 54" long crossbars which should give you a little bit of overhang on your canopy. Per…

view full answer...

Answer 10

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 11

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 12

Hey Alex, it sounds like you are looking for just the tracks of the Rhino Rack camper shell roof rack kit #Y02-480B which we do offer with the part #RTC16.

view full answer...

What is Replacement Self-Adhesive M5 Washer Made Of

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching