Recommended Ladder Rack Compatible with BAKFlip MX4 Tonneau on 2017 Toyota Tundra

Question

Question:

What Rack is compatable with Bakflip MX4 for 2017 Tundra. Thanks

asked by: Ross E

0

Expert Reply:

There is only one ladder rack that is compatible with the BAKFlip MX4, and that is the Adarac Pro Series ladder rack since it has uprights that are 90 degrees (perpendicular) to the truck bed rails. I've listed the Adarac Pro Series Ladder racks for each bed size that the 2017 Toyota Tundra is available with, so you'll want to choose from these:

5-1/2 Foot Bed # A4001665
6-1/2 Foot Bed # A4001671
8 Foot Bed # A4001676

All of these will allow your BAKFlip MX4 folding tonneau cover to fold up without interference from the uprights on the ladder rack, and they'll work with truck models both with and without the bed rail management system.

expert reply by: Erik B

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hi Larry, So we have a couple bumpers that may work, though each is 96 inches long. They can be cut to length though, and the difference is their width, as one is 3" wide and the other 4" wide to fit different size bumpers: - Pre-Drilled…

view full answer...

Answer 5

Hey Tim, thanks for the picture of your current brake assemblies. While what you have doesn't look exactly like a free-backing setup you definitely can replace what you have with them. For that I would go with the etrailer part #AKFBBRK-35 which…

view full answer...

Answer 6

Based on the information you provided either the Titan Hydraulic Brake Kit - Free Backing - 10" - Left and Right Hand Assemblies - 3,750 lbs #T4071600-500 or #T4423500-400 will fit your drums. The only difference between these two brakes is the…

view full answer...

Answer 7

According to Rhino Rack, if you were to go with the shorter bars, you'll only have 1-1/4 inch of leeway on each side which isn't enough in their opinion. I'd recommend going with the 71 inch bars so you'll be certain of a good fit. As…

view full answer...

Answer 8

I checked with Erickson and their Removable Motorcycle Wheel Chock item #EM07506 does not have a weight rating. It is made of steel and works with bikes that have up to 6" tires. So long as your Honda and Kawasaki do not have wider tires this…

view full answer...

Recommended Ladder Rack Compatible with BAKFlip MX4 Tonneau on 2017 Toyota Tundra

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching