Replacement Remote for MaxxFan Deluxe 5100K

Question

Question:

MAXXFAN 5100K A00099 remote

asked by: Randy H

0

Expert Reply:

The Replacement Handheld Remote for Maxxair Roof Vent Intake/Exhaust Fans - Qty 1 # MA00A01150K is what you need for compatibility with your 5100K model.

expert reply by: Jason S

0

Answer 1

I spoke with my contact at MaxxAir who said that if you lost the remote to your MaxxAir fan there is no programming that has to be done when using a replacement remote. Part #MA00A01150K is already compatible with all MaxxAir fans that have…

view full answer...

Answer 2

The Maxxair website doesn't list the 4900K as coming with a remote control option. It may have been something added by a manufacturer. The Replacement Handheld Remote for Maxxair Roof Vent Intake/Exhaust Fans - Qty 1 #MA00A01150K or the Exhaust…

view full answer...

Answer 3

Yes, the Replacement Handheld Remote #MA00A01150K is a compatible replacement for your MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat #MA00-05100K.

view full answer...

Answer 4

I went to the warehouse and pulled one of the Remote for Air Lift WirelessONE Compressor System, part #AL72704. I have attached a photo of the remote you can check out. On each side of the remote in the areas with the red arrows, there is a small tab…

view full answer...

Answer 5

Yes the Maxxair Remote part #MA00A01150K is compatible with the Maxxair vent assembly MA00-05100K that you referenced.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 12

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Replacement Remote for MaxxFan Deluxe 5100K

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching